Installation Instructions
CHANDELIER
INSTALLATION:
Tel: (613) 342-5424, Fax: (800) 263-4598
SAFETY PRECAUTIONS:
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Wiring supplies
as required by
local electrical
code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
ICH730A03
06/18
Mounting
bracket
Electrical
Box
Electrical box screws
(not included)
Power
cord
Chain
Chain
Canopy
1. Spread the arms evenly.
Secure the ring to the fixture with
the 3 nuts. Attach the glass shade
to the fixture using the thumb
screws (tighten with fingers only).
2. Mount the mounting bracket
to electrical box using electrical
box screws (not included). Make
sure the studs on the mounting
bracket are facing out from the
electrical box.
A. INSTALLATION FOR
CHANDELIER MOUNT
i. Determine the height that you
would like to hang your fixture.
Trim the cord and chain. Allow 10”
of extra wiring for the electrical
box connections.
ii. To attach chain loop to light
fixture, use a screwdriver and
wrench to open and close chain
loop. Ensure to close the opening.
Weave the power cord and
ground wire through the links in
the chain.
iii. Hook the chain to the upper
loop. Feed the cord and ground
wire through the upper loop.
B. INSTALLATION FOR SEMI
FLUSH MOUNT
i. Remove the loop and cap by
unscrew the 2 cap nuts and star
washers.
3. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw in
the electrical box. Connect the black
wire (or wire marked “SPT-1”) from
the fixture to the black wire in the
electrical box and connect the
white wire (or the wire with ribbed
side) from the fixture to the white
wire in the electrical box.
4. Once connections of wires are
completed, carefully tuck wires and
wire nuts into the electrical box
making sure no bare wire (on the
black and white) is visible at the
wire nuts.
5. Position fixture over studs on
mounting bracket assembly. Secure
fixture in place with star washers
and cap nuts.
6. Install specified bulb type and
wattage (not included).
Nut
Thumb
Screw
Ring
Shade
Star
Washer
Cap
Nut
Fixture
Stud
White
Black
House supply
Ground wire
Fixture
Ground wire
Loop
Cap
Cap Nut
Star
Washer
Upper loop
Cord
Ground Wire