Instructions / Assembly

OUTDOOR
POST LIGHT
1. Pour cement base for the lamp.
2. Place anchor bolts into the cement with the base plate sitting on top of the
cement holding the bolts in proper position. Make sure the anchor bolts are
above the cement sufficiently to clear through the base when assembled. Make
sure the power supply passes through the centre hole of the base plate. (Note:
make sure the surface of the cement is level). After the cement is cured, proceed
with the next step.
3. Assemble the three arms to the centre post using two hex nuts and two
lockwashers for each one.
4. Screw the centre nipple into the bracket in the centre post and secure
using a hex nut.
5. Feed the power leads up through the base and bolt the base to the anchor
bolts using anchor bolt nuts.
6. Align the holes on the mounting cup with the holes in your existing post
and secure with mounting screws.
7. Feed the power supply through the lower post and upper post. Feed power
supply through the cable tie. Tighten the cable tie so that the power supply
tightens against the bar.
8. Connect the power supply to the head assembly. Attach the black wire to
the black wires. Attach the white wire to the white wires. Ground wire from
power supply should be attached to ground wire from bar inside the head
assembly.
9. Screw the upper post into the head assembly (be careful not to twist the
wires).
10. Screw the lower post into the upper post.
11. Set the assembled pieces (lower post, upper post & head assembly) onto
the base and secure in place using bolts.
12. Unscrew the finial and remove the finial and rubber washer and the top
cap of each lantern (3 lanterns). Install the proper bulb type and wattage. Place
the top cap and rubber washer back on the fixture and secure in place by
threading the finial back onto the nipple until it is snug.
INSTALLATION:
Finial
Arm
Centre Post
Nuts
Lockwashers
Top Cap
Nipple
Upper
Post
Lower
Post
Base
Base Plate
Anchor Bolts
Power
Top Cap
Anchor Bolt
Nuts
Bar
Ground
Head Assembly
Upper
Post
Cable Tie
Power
Supply
White
Black
Head Assembly
IOL151
09/17
Rubber Gasket
Screws
Tel: [phone], Fax: [phone]
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED.
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
local electrical
code
NOTE: Product may not look exactly as shown in figures.