Product Manual

1. Attach nipple to mounting bracket. Adjust so it will clear hole
in back of fixture and then lock nipple in place with hex nut.
2. Attach mounting bracket to electrical box with electrical box
screws (not included).
3. Firmly attach the fixture ground wire (bare copper) to the
mounting bracket with the ground screw (by wrapping around the
ground screw) and then connect it to the house supply ground wire
with a wire nut. Connect black wire from fixture to black wire in
outlet box and connect the white wire from fixture to white wire in
outlet box.
4. Once connections of wires are completed, carefully tuck wires
and wire nuts into the outlet box making sure no bare wire (on the
black and white) is visible at the wire nuts. Position hole in
fixture over nipple and secure in place with cap nut.
5. Install proper bulb type and wattage (not included).
6. Position glass inside guard and place on fixture. Secure in
place with two screws or cap nuts and tighten until gaskets seal.
NOTE: After Installation, seal around the top and side perimeter
between the fixture and the wall surface with weather resistant
caulking. The bottom should be left un-caulked to prevent
moisture build-up.
7. If necessary, install the gasket on the base of the fixture as
shown in the diagram.
Mounting
Bracket
Electrical Box
Cap Nut
Nipple
Screws
White
Black
Ground
Screw
IOL15
IOL15
IOL15
IOL16 or IOL75
IOL16
or IOL75
IOL16 or
IOL75
IOL17
IOL17
IOL17
Cap
Nuts
Hex Nut
Nipple
Mounting Bracket
INSTALLATION: NOTE: PRODUCT MAY NOT LOOK EXACTLY AS SHOWN IN FIGURES.
O-5
07/12
SAFETY PRECAUTIONS:
OUTDOOR LIGHTING
Wet Location Fixture
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
DO NOT REMOVE INSULATION FROM FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
3. FIRMLY ATTACH THE FIXTURE GROUND WIRE (BARE COPPER) TO THE MOUNTING BRACKET WITH THE
GROUND SCREW (BY WRAPPING AROUND THE GROUND SCREW) AND THEN CONNECT IT TO THE
HOUSE SUPPLY GROUND WIRE WITH A WIRE NUT.
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) / 1-800-567-2513 (French) Monday through Friday 8:00 AM to 5:00 PM E.S.T.
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
!
“INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS”
“READ ALL INSTRUCTIONS”
“IMPORTANT SAFETY
INSTRUCTIONS”
“SAVE THESE INSTRUCTIONS”
TOOLS AND MATERIALS REQUIRED:
Blade
Screwdriver
Pliers
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
House Supply
Ground Wire
Fixture
Ground Wire
White wire
Black wire
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]