Installation Instructions

SAFETY PRECAUTIONS:
OUTDOOR LIGHTING
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED.
3. FIRMLY ATTACH THE FIXTURE GROUND WIRE (BARE COPPER) TO THE MOUNTING BRACKET WITH THE
GROUND SCREW (BY WRAPPING AROUND THE GROUND SCREW) AND THEN CONNECT IT TO THE
HOUSE SUPPLY GROUND WIRE WITH A WIRE NUT.
INSTALLATION:
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
356-9052
05/15
QUESTIONS OR CONCERNS CONTACT PATRIOT AT:
1-800-267-4427 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T. or email to: [e-mail]
NOTE: Product May Not Look Exactly As Shown In Figures.
Wheather Resistant
Caulking
(not included)
1. Attach nipple to mounting
bracket and adjust until it will
clear fixture when assembled.
Lock in place using the hex nut.
2. Mount the mounting
bracket to electrical box using
outlet box screws
(not
included)
. Make sure the
nipple on the mounting bracket
are facing out from the
electrical box.
3. Firmly attach the fixture
ground wire (bare copper) to
the mounting bracket with the
ground screw (by wrapping
around the ground screw) and
then connect it to the house
supply ground wire with a wire
nut. Connect black wire from
fixture to black wire in electrical
box and connect the white wire
from fixture to white wire in
electrical box.
4. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no
bare wire (on the black and
white) is visible at the wire nuts.
Tuck electrical wires into outlet
box and position fixture over
nipple on mounting bracket
assembly. Secure fixture in
place with star washer and cap
nut.
Star
Washer
Mounting
Bracket
Cap Nut
Electrical
Box
5. Install proper bulb type
and wattage (not included).
6. Position the cover in
place and secure with the
screw.
7. After Installation, seal
around the top and side
perimeter between the
fixture and the wall surface
with weather resistant
caulking. The bottom
should be left un-caulked to
prevent moisture build-up.
Nipple
Nipple
Hex Nut
Electrical Box Screws
(not included)
Screw
Cover
White
Black
House
supply
Ground
wire
Fixture
Ground wire