Installation Instructions

SAFETY PRECAUTIONS:
OUTDOOR LIGHTING
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED.
3. FIRMLY ATTACH THE FIXTURE GROUND WIRE (BARE COPPER) TO THE MOUNTING BRACKET WITH THE
GROUND SCREW (BY WRAPPING AROUND THE GROUND SCREW) AND THEN CONNECT IT TO THE
HOUSE SUPPLY GROUND WIRE WITH A WIRE NUT.
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
IOL288
10/15
NOTE: Product May Not Look Exactly As Shown In Figures.
1. Mount the mounting
bracket to electrical
box using
electrical box screws (not
included). Make sure the studs
on the mounting bracket are
facing out from the electrical box.
2. Firmly attach the fixture
ground wire (bare copper) to the
mounting bracket with the
ground screw (by wrapping
around the ground screw) and
then connect it to the house
supply ground wire with a wire
nut. Connect black wire from
fixture to black wire in electrical
box and connect the white wire
from fixture to white wire in
electrical box.
3. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no
bare wire (on the black and
white) is visible at the wire nuts.
4. Install the light fixture to the
wall by aligning the hole(s) in the
fixture with the studs on the
mounting bracket. Secure in
place with cap nut(s) and star
washer (s).
5. Install specified bulb type and
wattage (not included).
6. Slide the glass down and secure
with the two screws.
7. After Installation, seal around
the top and side perimeter between
the fixture and the wall surface with
weather resistant caulking. The
bottom should be left un-caulked to
prevent moisture build-up. Apply a
small amount of weather resistant
caulking around the side perimeter
between the cap nut and mounting
plate.
Electrical Box Screws
(not Included)
Electrical
Box
INSTALLATION:
Wheather Resistant
Caulking
(not included)
Mounting
Bracket
Studs
White
Black
House supply
Ground wire
Fixture
Ground wire
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]
Star
Washer
Stud
Cap
Nut
Screw
Glass
Bulb