Installation Instructions

1. Determine the height that you
would like to hang your fixture.
Trim the cord and chain. Allow 10”
of extra wiring for the electrical box
connections.
2. Loosen the upper connector
from nipple. Thread nipple into
mounting bracket, adjust nipple so
it clears the canopy when installed.
Lock in place by threading hex nut
onto nipple and tighten against
mounting bracket. Attach mounting
bracket to electrical box with
electrical box screws (not included).
3. To attach chain loop to light
fixture, use a screwdriver and
wrench to open and close chain
loop. Ensure to close the opening.
Weave the power cord and ground
wire through the links in the chain.
4. Loosen the nut on the upper
connector and slide it down the
chain towards the lower connector.
Slide the canopy down the chain
towards the lower connector. Feed
the wire through nut, canopy, the
upper connector and onto the
nipple. Tighten the upper
connector onto the nipple. Spread
the other end of the chain open and
fasten to the upper connector.
Ensure the opening is closed.
Nipple
Nipple
Hex Nut
Electrical Box Screws
(not included)
Upper
Connector
Mounting
Bracket
Cord
Chain
Connector
Lower
Nipple
Upper
Connector
Nut
Canopy
5. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground
screw in the electrical box.
Connect the black wire from
the fixture to the black wire in
the electrical box and connect
the white wire from the fixture to
the white wire in the electrical
box.
6. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no
bare wire (on the black and
white) is visible at the wire nuts.
7. Slide the canopy up the
chain and over the upper
connector. Slide the nut up the
chain and thread onto the upper
connector.
8. Install proper bulb type and
wattage (not included).
Canopy
Nut
White
Black
OUTDOOR LIGHTING
IOL432
01/19
SAFETY PRECAUTIONS:
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Wiring supplies
as required by
local electrical
code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Tel: [phone], Fax: [phone]
Electrical
Box
House supply
Ground wire
Fixture
Ground
wire
Bulb