Installation Instructions

4.
Note:
5.
over studs or nipple on
mounting bracket assembly.
Secure fixture in place with
star washer(s) and cap nut(s).
Style#1 - Screw the glass ring
flrmly into the fixture socket.
Style#2 - Install proper bulb
type and wattage. Remove the
finishing screws that are
already on your fixture.
Position glass in place and
secure with finishing screws.
Style#3 - Remove spinner nut
from the socket. Place the
glass onto the fixture socket.
Use the special tool that
comes with your fixture to
tighten the spinner nut onto
the socket to secure the glass
in place. Install the proper bulb
type and wattage.
INSTALLATION:
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
5. Tuck electrical wires into
outlet box and position fixture
over studs on mounting bracket
assembly. Secure fixture in place
with star washers and cap nuts.
Star
Washer
Cap
Nut
Fixture
1. Install the length of rod(s)
that is required by threading wire
through the rod(s) and screwing it
to the fixture.
2. NOTE: Refer to the style of
assembly that matches the style
of your fixture.
Loosen “B”.
Adjust stud to desired length and
lock in place with “B”.
3. Mount the mounting bracket
to outlet box using outlet box
screws (not included). Make sure
the studs or nipple on the
mounting bracket are facing out
from the outlet box.
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
White
Black
House
supply
Ground wire
Fixture
Ground wire
PENDANT LIGHT
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) 1-800-567-2513 (French) Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: [phone], Fax: [phone]
Stud
NOTE: Product May Not Look Exactly As Shown In Figures.
4. Connect the ground wires
(bare copper or green) from your
fixture to the ground wires (bare
copper or green) or ground screw
in the electrical outlet box.
Connect black wire from fixture to
black wire in outlet box and
connect the white wire from
fixture to white wire in outlet box.
6. Install the proper bulb type
and wattage (not included).
7. Screw glass cylinder on to the
fixture.
8. Install the guard with the nuts.
Studs
Studs
“B”
“B”
Glass
Canopy
Rod(s)
Mounting Bracket
Outlet
Box
Outlet
Box Screws
(not included)
Mounting Bracket
IPL526A
12/13
Guard
Nut