Installation Sheet

INSTALLATION:
1. Screw the centre rod and
canopy to the fixture.
2. Loosen “B”. Adjust stud to
desired length and lock in place
with “B”
3. Mount the mounting
bracket to electrical box using
electrical box screws (not
included). Make sure the studs
on the mounting bracket are
facing out from the electrical
box.
4. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw
in the electrical box. Connect the
black wire from the fixture to the
black wire in the electrical box and
connect the white wire from the
fixture to the white wire in the
electrical box.
5. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no bare
wire (on the black and white) is
visible at the wire nuts.
6. Position fixture over studs on
mounting bracket assembly.
Secure fixture in place with star
washer(s) and cap nut(s).
7. Install specified bulb type and
wattage (not included).
8. Remove the thumb screws
that are already on your fixture.
Attach the glass shade to the
fixture using the thumb screws
(tighten with fingers only).
White
Black
House supply
Ground wire
Fixture
Ground wire
Tel: [phone], Fax: [phone]
ISF679A03
09/16
Star
Washer
Cap
Nut
Fixture
Fixture
Stud
“B”
Studs
Mounting
Bracket
Electrical
Box
Electrical
Box Screws
(not included)
SAFETY PRECAUTIONS:
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Wiring supplies
as required by
local electrical
code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
SEMI-FLUSH
MOUNT
Centre
rod
Canopy
Thumb
Screw
Shade
Bulb