User manual

Index Phason
62
operating program .......................................... 35
P
parameters .......... 22–24, See also programming or
configuration
power ........ See incoming power or three-phase
power
power contactors ........................................ 7, 44
power surges ................................................ 5–6
probes .......................... See temperature probes
programming
alarm settings ....................................... 31–33
group set point ........................................... 25
relay stages .......................................... 27–30
variable stages ..................................... 26–27
proportional control ............................ 20, 28–30
R
relay stages .............................................. 27–30
relay terminals .................................................. 8
responding to alarms................................ 35–36
restoring factory defaults ................................ 39
restoring settings ...................................... 40–41
ribbon cable ...................................................... 8
S
saving settings .......................................... 40–41
SEC-HD Saver .................................... 40–41, 43
SEC-HD Updater ................................ 41–42, 43
selecting
frequency .............................................. 17–18
temperature units ....................................... 17
settings saver ....................... See SEC-HD Saver
stage override mode ................................. 36–37
stages .................................... See relay or variable
status LEDs ...................................................... 3
surge suppression ......................................... 5–6
T
temperature override ........................... 25, 37–38
temperature probes ..................................... 8, 44
temperature units ........................................... 17
testing ........................................................ 36–38
three-phase power ......................................... 12
U
units ................................ See temperature, units
updating firmware ..................................... 41–42
V
variable stage terminals ................................... 8
variable stages
configuring ................................................. 19
connecting ................................................. 11
programming ........................................ 26–27
ventilation off/on ........................................ 38–39
version ........................................... See firmware
voltage selection switch ................................... 8