User Guide

(Step 4 cont’d)
If you want to adjust the Secure Mount’s
level after fastening the baseplate to the
installation surface, loosen the right screw
and rotate the baseplate accordingly before
tightening.
Step 5: Hook the Secure Mount onto the
baseplate.
Align the top of the Secure Mount base with
the two hooks at the top of the baseplate,
then snap the bottom into place.
Step 6: Secure the base to the baseplate.
Using the provided hex tool, tighten the hex
screw on the bottom of the base.
Step 7: Install your Canary Flex device.
Insert your Canary Flex device into the
Secure Mount and adjust it to the preferred
angle. Make sure the LED ring is not covered
by the cup before securing.
Note: Do not twist your Canary Flex device
itself to secure it.
Use the provided hex tool to secure the
mounting screw to the bottom of your
device.
Step 8: Adjust the angle.
Adjust the angle of your Canary Flex device
by pressing the button on the top of the
Secure Mount and rotating the device until
it’s in the desired position.
Step 9: Connect to power. (optional)
If you plan to keep your Canary Flex device
plugged in, connect the power cable to the
back of your device and route the cable
around the secure mount in the direction of
your power outlet.
Note: Make sure you use a covered
weatherproof outlet if you plan to keep your
Canary Flex device plugged in outdoors.