User Manual

CanDo HD Diagnostic Tablet
27
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
SAR tests are conducted using
standard operating positions accepted by the FCC with the MID
transmitting at its highest certified power level in all tested frequency
bands, although the SAR is determined at the highest certified power level,
the actual SAR level of the phone. While operating can be well below the
maximum value, in general, the closer you are to a Wireless base station
antenna, the lower the power output. Before a new model phone is a
available for sale to the public, it must be tested and certified to the FCC
that it does not exceed the exposure limit established by the FCC, Tests for
each phone are performed in positions and locations (e.g. at the ear and
worn on the body)as required by the FCC.
For body worn operation, this model MID has been tested and meets
the FCC RF exposure. Guidelines when used with an accessory designated