Owner manual

13
ENGLISH
Trouble shooting
Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.
Drying time is too long/clothes are not
dry enough:
Have you selected the correct drying
time/programme? Go to page 9.
Were the clothes too wet? Were the
clothes thoroughly wrung or spin-
dried?
Does the filter need cleaning? Go to
page 7.
Does the condenser need cleaning? Go
to page 8.
Is the dryer overloaded? Go to page 6.
Are the inlets, outlets and base of the
dryer free from obstructions?
Has the button been selected from a
previous cycle? Go to page 10.
The dryer does not operate:
Is there a working electricity supply to
the dryer? Check using another
appliance such as a table lamp.
Is the plug properly connected to the
mains supply?
Is there a power failure?
Has the fuse blown?
Is the door fully closed? Go to page 11.
Is the dryer switched on, both at the
mains supply and at the machine? Go to
page 10.
Has the drying time or the programme
been selected? Go to page 10.
Has the machine been switched on
again after opening the door? Go to
page 7.
Has the dryer stopped operating
because the water tray is full and needs
emptying? Go to page 8.
Filter Care Indicator on
Does the filter need cleaning? Go to
page 7.
Empty Water Indicator on
Does the water container need
emptying? Go to page 8.
If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from GIAS
Service or an authorised Dealer.
Should there still be a problem with your
dryer after completing all the
recommended checks, please call GIAS
Service for advice. They may be able to
assist you over the telephone or arrange for
a suitable appointment for an engineer to
call under the terms of your guarantee.
However, a charge may be made if any of
the following applies to your machine:
Is found to be in working order.
Has not been installed in accordance
with the installation instructions.
Has been used incorrectly.
40001731English.fm Page 13 Monday, September 6, 2004 4:21 PM