User Manual
11 
The Cooker hood 
inclines 
The fixing screw is not tight 
enough 
Tighten the hanging screw and 
make it horizontal. 
NOTE: 
Any electrical repairs to this appliance must conform to your local, state and 
federal laws.Please contact the service centre if in any doubt before 
undertaking any of the above. Always disconnect the unit from the power source when 
opening the unit. 
MAINTENANCEANDCLEANING
Caution: 
• Before maintenance or cleaning is carried out, the cooker hood should be 
disconnected from the mains power supply. Ensure that the cooker hood is switched 
off at the wall socket. 
• External surfaces are susceptible to scratches and abrasions, so please follow the 
cleaning instructions to ensure the best possible result is achieved without damage. 
GENERAL 
Cleaning and maintenance should be carried out with the appliance cold especially 
when cleaning.Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on 
the surfaces. 
STAINLESS STEEL 
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life 
expectancy.Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may 
be used. 
NOTE: 
Ensure that wiping is done along with the grain of the stainless steel to prevent any 
unsightly crisscross scratching patterns from appearing. 
CONTROL PANEL SURFACE 
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is 
clean and well wrung before cleaning. Use a dry soft cloth to remove any excess 
moisture left after cleaning. 
Important 
Using neutral detergents and avoid using harsh cleaning chemicals, strong household 
detergents or products containing abrasives,as this will affect the appearance of the 
appliance and potentially remove any printing of artwork on the control panel and will 
void manufactures warrantee. 
GREASE MESH FILTERS 
The mesh filters can be cleaned by hand. Soak them for about 3 minute in water with a 
mild detergent and then brush it gently with a soft brush. Please do not apply too much 
pressure so as to avoid any damage to it . (Leave to dry naturally out of direct sun light) 










