EN User instructions CDI 1012 DISHWASHER
Congratulations! CUSTOMER SERVICE AND GUARANTEE Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability. Candy manufacture a vast range of domestic appliances: washing machines, washer/dryers, cookers, microwave ovens, ovens and hobs, refrigerators and freezers. Ask your dealer for the catalogue with the complete range of Candy products.
CONTENTS pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag. pag.
■ The door should not be left in the open position since this could present a potential hazard ( es. tripping ). SAFETY INSTRUCTIONS There are certain basic safety rules which are valid for any domestic appliance. ■ Leaning or sitting on the open door of the dishwasher could cause it to tip over. WARNING ! Knives and other utensils with sharp points must be loaded in the basket with their points down or placed in a horizontal position.
■ Cutlery is washed best if it is placed in the basket with the handles downwards. Disposal ■ If the appliance breaks down or stops working properly, switch it off, turn off the water supply and do not tamper with it. Repair work should only be carried out by an approved service agent and only genuine spare parts should be fitted. Any failure to follow the above advice may have serious consequences for the safety of the appliance.
Water connection IMPORTANT The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. 1 ■ The inlet and drain hoses can be directed to left or right. IMPORTANT The dishwasher can be connected to either cold or hot water, as long as it is no hotter than 60 °C. 2 ■ Water pressure must be between 0,08 MPa and 0,8 MPa. If the pressure is below the minimum consult our service department for advice.
■ The hose can be hooked over the side of the sink, but it must not be immersed in water, in order to prevent water from being syphoned back to the machine when this is in operation (fig. 4Y). Connecting the outlet hose ■ The outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. 4). ■ When installing the appliance under a worktop the hose pipe clamp must be attached to the wall in the highest possible position under the worktop (fig. 4Z).
FOR 1 570 600 This dishwasher model can be embedded in modular furniture, under a counter top, a continuous counter top or a sink. 550 820+(80) 598 160 ■ The housing dimensions must be the same as those indicated in the figure 1. 100 +(80) 170 820+(80) TECHNICAL NOTES CABINET FITTERS 40 ■ The adjustable feet allow the height of the machine to be varied from 820 to 900 mm.
■ Fix the frames with the other 6 screws 4x16 mm in the specif holes (fig. 6). Drilling arrangements ■ Drill 12 mm deep holes in the panel using a 2 mm diameter drill according to the measures indicated in the figure 5. ■ Fasten the panel to the dishwasher door with the screws 3.5 x 13 mm (fig. 7). ■ Fasten the two supplied frames with 4 of the 4 x 16 mm diameter screws, setting them at the center of the eyelets (fig. 6).
WATER SOFTENER UNIT * The water softener unit is set in the factory at level 3, as this is suitable for the majority of users. Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is.
use of the appliance, it should be refilled from time to time according to the regulation of the water softener unit. Loading the salt ■ On the bottom of the machine there is a container for the salt for regenerating the softener. IMPORTANT (Only for first start up) When the appliance is used for the first time, after completely filling the salt container, it is necessary to add water until the container overflows. ■ It is important to use only a salt that is specifically designed for dishwasher.
Adjustment of the upper basket If 29 cm to 32,5 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: A 1. Turn the front stops “A” outwards; 2. Take out the basket and remount it in the upper position; 3. Replace the blocks “A” in their original position.
A standard daily load is represented in figs. 1, 2 and 3. LOADING DISHES Using the upper basket Upper basket (fig. 1) A = soup plates B = dinner plates C = dessert plates D = saucers E = cups F = glasses ■ The upper basket is provided with mobile racks hooked to the sides of the basket, which can be regulated into 4 positions. ■ In the lowered position (A-A1) the racks may be used for such items as: tea and coffee cups, kitchen knives and ladles.
A standard daily load is represented in figs. 4 and 5. Upper basket (fig. 3) A = glasses B = saucers C = cups D = small bowl E = medium bowl F = large bowl G = serving spoons Lower basket (fig.
Cutlery basket (fig. 6) 6 The cutlery basket is made with two detachable parts which will enable various loading options. The two parts can be detached by sliding the left section away from the right section. The top of cutlery basket can be removed, for enable various loading options. INFORMATION FOR THE TEST LABORATORIES Please ask information required for comparison testing and measuring noise levels, according to EN normative, to the following address: testinfo-dishwasher@candy.
LOADING THE DETERGENT The detergent IMPORTANT It is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid or tablet form. B After pouring the detergent into the container, close the lid, firstly pushing (1) and then pressing on it (2) until you hear the click. “FINISH” gives very good results and can be easily obtained.
■ the effectiveness of detergents containing the built in water softener/salt depends on the hardness of your water supply. Check that the hardness of your water supply is within the effective range given on the detergent packaging. TYPES OF DETERGENT Detergent tablets Detergent tablets of different manufacturers dissolve at different speeds, for this reason, during short programmes, some detergent tablets may be not fully effective, because they are not completely dissolved.
LOADING THE RINSE AID The rinse aid The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. Filling the rinse aid container C The rinse aid container can be found to the left of the detergent container (fig. A "3"). To open the lid, push the reference mark and, in the same time, pull the tab of opening. It is always advisable to use rinse aid that is specifically designed for dishwasher.
CLEANING THE FILTERS The filter system (fig.A “4”) consists of: 1 a central container that traps the larger particles; a flat gauze that continuously filters the wash water; a micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse. ■ To achieve excellent results every time, the filters should be checked and cleaned after each wash. ■ To remove the filter unit, simply turn the handle anticlockwise (fig. 1).
PRATICAL HINTS How to make savings ■ If you want the dishwasher to give a complete wash, place the dishes in the dishwasher at the end of each meal and if necessary turn on the COLD RINSE cycle to soften the food remains and remove bigger particles of food from the new load of dishes. When the dishwasher is full start the complete wash cycle programme.
CLEANING AND MAINTENANCE 1 1b ■ To clean the dishwasher outside, do not use solvents (degreasing action) neither abrasives, but only a cloth soaked with water. ■ The dishwasher does not require special maintenance, because the tank is self-cleaning. ■ Regularly wipe the door gasket with a damp cloth to remove any food remains or rinse aid.
DESCRIPTION OF THE CONTROL PANEL D C A B A "ON/OFF" button C "PROGRAMME SELECTION" button B PROGRAMME DESCRIPTION D "PROGRAMME SELECTION" indicator lights DIMENSIONS 59,8 x 82 ÷ 90 x 55 117 Width x Height x Depth (cm) Depth with door open (cm) TECHNICAL DATA 12 8 persons Min. 0,08 - Max.
PROGRAMME SELECTION AND SPECIAL FUNCTIONS Changing a running programme Proceed as follows to change or cancel a running program: (Use in conjunction with programme guide) Programme settings ■ Hold the "PROGRAMME SELECTION" button down for at least 5 seconds. The programme indicator lights will turn on and off individually and sequentially and some audible signals will sound. ■ Open the door and place the dirty dishes inside the appliance. ■ Press the "ON/OFF" button .
Alarm mute for the PROGRAMME END Memorization of the last programme used The alarm for the programme end may be muted as follows: The last programme used can be memorized by following the below: IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. 1.
Fault signals IMPORTANT This dishwasher is equipped with an anti-overflow safety device which will automatically discharge any excess water should a problem occur. If malfunctions or faults occur when a programme is running the indicator light that corresponds to the selected cycle (2 indicator lights for the "COLD RINSE" programme) will flash rapidly and the alarm sounds. In this event, turn the dishwasher off by pressing the "ON/OFF" button.
PROGRAMME GUIDE Description Programme Once a day - for normal soiled pans and any other items that have been left all day for washing. UNIVERSAL Once a day - for heavily soiled pans and any other items that have been left all day for washing. HYGIENIC ECO Programme for normally soiled tableware (the most efficient in terms of its combined energy and water consumption for that type of tableware). Programme standardised to EN 50242.
• • • • • • • • • • • • • • • • 27 60°C • • 120 75°C • • • 135 45°C • 170 50°C • 32 Second cold rinse First cold rinse With cold water (15°C) -Tolerance ± 10%- • • • • • • Hot rinse with rinse aid • Main wash Cold pre-wash Hot pre-wash Check salt container Check rinse aid dispenser Clean filter Detergent for washing Detergent for soaking (Prewash) Check list Programme contents Avarage duration in minutes 5
IDENTIFYING MINOR FAULTS Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: FAULT 1 - Machine completely dead 2 - Machine does not draw water 3 - Machine does not discharge water 4 - Machine discharges water continuously 5 - Spray arms are not heard to rotate 6 - On electronic appliances without a display: one or more LED flashing quickly.
FAULT CAUSE See causes for no.
The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics. To consult the product fiche, please refer to the manufacturer website.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste.
