EN Freezer - Fridge / User Manual
Thank you for choosing this product. This user manual contains important information on safety and instructions intended to assist you in the operation and maintenance of your appliance. Please take the time to read this user manual before using your appliance and keep this book for future reference.
CONTENTS 1 SAFETY INSTRUCTIONS................................................................................ 4 1.1 General Safety Warnings................................................................................................4 1.2 Installation warnings........................................................................................................8 1.3 Electrical information (For UK type plug).........................................................................8 1.4 During Usage.....
1 SAFETY INSTRUCTIONS 1.1 General Safety Warnings Read this user manual carefully. WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
natural gas, but it is explosive. In the event of a leak due to damage of the cooler elements, move your fridge away from open flames or heat sources and ventilate the room where the appliance is located for a few minutes. • While carrying and positioning the fridge, do not damage the cooler gas circuit. • Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
To avoid contamination of food, please respect the following instructions: • Opening the door for long periods can cause a significant increase of the temperature in the compartments of the appliance. • Clean regularly surfaces that can come in contact with food and accessible drainage systems • Store raw meat and fish in suitable containers in the refrigerator, so that it is not in contact with or drip onto other food.
1.2 Installation warnings Before using your fridge freezer for the first time, please pay attention to the following points: • The operating voltage for your fridge freezer is 220-240 V at 50Hz. • The plug must be accessible after installation. • Your fridge freezer may have an odour when it is operated for the first time. This is normal and the odour will fade when your fridge freezer starts to cool.
The mains lead of this appliance has been fitted with a BS 1363A 13A fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. 1.4 During Usage • Do not re-freeze thawed frozen food. This may cause health issues such as food poisoning.
Packaging and the Environment Packaging materials protect your machine from damage that may occur during transportation. The packaging materials are environmentally friendly as they are recyclable. The use of recycled material reduces raw material consumption and therefore decreases waste production. Notes: • Please read the instruction manual carefully before installing and using your appliance. We are not responsible for the damage occurred due to misuse.
2 DESCRIPTION OF THE APPLIANCE 1 2 A 3 4 12 5 6 7 11 B 8 10 13 9 14 This presentation is only for information about the parts of the appliance. Parts may vary according to the appliance model.
D2 D1 2.1 Dimensions W2 D3 H2 H1 W1 90o Overall dimensions 1 H1 mm 1860 W1 mm 595 D1 mm 650 1 t he height, width and depth of the appliance without the handle. Overall space required in use 3 Space required in use 2 H2 mm 2010 W2 mm 695 D2 mm 744,1 2 t he height, width and depth of the appliance including the handle, plus the space necessary for free circulation of the cooling air.
3 USING THE APPLIANCE 3.2 Display and Control Panel 3 3.1 Information about New Generation Cooling Technology Fridges with new-generation cooling technology have a different operating system to static fridges. Other (static) fridges may experience a build up of ice in the freezer compartment due to door openings and humidity in the food.
NOTE: Eco mode gets activated automatically when the temperature of the freezer compartment is set to -18°C. the environmental temperature or when the freezer sensor reaches a sufficiently low temperature. Recommended Settings for the Freezer and Cooler Compartment Temperature 3.3.2 Cooler Temperature Settings • The initial temperature value for the cooler setting indicator is +4 °C. • Press the cooler button once.
of food in the fridge. Please note that, depending on the ambient temperature, it may take 24 hours for your fridge to reach the operating temperature. • A 5 minute delay function is applied to prevent damage to the compressor of your fridge when connecting or disconnecting to mains, or when an energy breakdown occurs. Your fridge will begin to operate normally after 5 minutes.
4 FOOD STORAGE 3.5.3 The Fresh Dial (In some models) Fresh dial 4.1 Refrigerator Compartment If the crisper is full, the fresh dial located in front of the crisper should be opened. This allows the air in the crisper and the humidity rate to be controlled, to increase the life of food within. The dial, located behind the shelf, must be opened if any condensation is seen on the glass shelf.
products and clean any leakages on the shelves. • Do not put food in front of the air flow passage. • Consume packaged foods before the recommended expiry date. NOTE: Potatoes, onions and garlic should not be stored in the refrigerator. • For normal working conditions, it will be sufficient to adjust the temperature setting of your refrigerator to +4 °C.
temperature and that the contents have deteriorated. • The storage life of frozen food depends on the room temperature, the thermostat setting, how often the door is opened, the type of food, and the length of time required to transport the product from the shop to your home. Always follow the instructions printed on the packaging and never exceed the maximum storage life indicated. • The maximum amount of fresh food (in kg) that can be frozen in 24 hours is indicated on the appliance label.
5 CLEANING AND MAINTENANCE Disconnect the unit from the power supply before cleaning. Do not wash your appliance by pouring water on it. Do not use abrasive products, detergents or soaps for cleaning the appliance. After washing, rinse with clean water and dry carefully. When you have finished cleaning, reconnect the plug to the mains supply with dry hands. • Make sure that no water enters the lamp housing and other electrical components.
6 SHIPMENT AND REPOSITIONING 6.1 Transportation and Changing Positioning • The original packaging and foam may be kept for re-transportation (optional). • Fasten your appliance with thick packaging, bands or strong cords and follow the instructions for transportation on the packaging. • Remove all movable parts (shelves, accessories, vegetable bins, and so on) or fix them into the appliance against shocks using bands when re-positioning or transporting. Always carry your appliance in the upright position.
7 BEFORE CALLING AFTER-SALES SERVICE Errors Your fridge will warn you if the temperatures for the cooler and freezer are at improper levels or if a problem occurs with the appliance. Warning codes are displayed in the freezer and cooler indicators. ERROR TYPE MEANING WHY WHAT TO DO E01 Sensor warning Call Service for assistance as soon as possible. E02 Sensor warning Call Service for assistance as soon as possible. E03 Sensor warning Call Service for assistance as soon as possible.
ERROR TYPE E10 E11 MEANING Fridge compartment is not cold enough Fridge compartment is too cold WHY Likely to occur after: --Long term power failure. --Hot food has been left in the fridge. Various WHAT TO DO 1. Set the fridge temperature to a colder value or set Super Cool. This should remove the error code once the required temperature has been reached. Keep doors closed to improve time taken to reach the correct temperature. 2.
Humidity increases faster if the doors are opened frequently, especially if the humidity of the room is high. • There is a build-up of water droplets on the rear wall. This is normal after automatic defrosting (in Static Models). The doors are not opening or closing properly Check if: • There is food or packaging preventing the door from closing • The door compartments, shelves and drawers are placed properly • The door gaskets are broken or torn • Your fridge is level.
9 TECHNICAL DATA The technical information is situated in the rating plate on the internal side of the appliance and on the energy label. The QR code on the energy label supplied with the appliance provides a web link to the information related to the performance of the appliance in the EU EPREL database. Keep the energy label for reference together with the user manual and all other documents provided with this appliance.
11 CUSTOMER CARE AND SERVICE Always use original spare parts. When contacting our Authorised Service Centre, ensure that you have the following data available: Model, Serial Number and Service Index. The information can be found on the rating plate. Subject to change without notice. The original spare parts for some specific components are available for a minimum of 7 or 10 years, based on the type of component, from the placing on the market of the last unit of the model.
EN - 26
EN - 27
52354825