INSTRUCTION BOOK EVOC 580B Condenser Tumble Dryer English - 2 Dansk 13 Norsk 24 Svenska 35 Suomi 46 Italiano 57 Español 68 Deutsch 79 Français 90 Ελληικα 101 Slovensko 112
INDEX Introduction Delivery Information Unpacking the Product Safety Reminders Use Installation The Laundry Environmental Issues Gias Service Installation Electrical Requirements Adjusting the Feet Ventilation Preparing the Load Clothes Preparation Do Not Tumble Dry Energy Saving Sorting the Load Drying Guide Controls and Indicators Selecting the Programme Door and Filter Opening the Door Filter Filter Care Indicator Water Container To Remove the Container Condenser To Remove the Condenser Operation Delay S
INTRODUCTION Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners.
SAFETY REMINDERS Installation ● Check that the product has no visible signs of damage before use. If damaged do not use and please call GIAS Service. ● Do not use adapters, multiple connectors and/or extensions. ● Never install the dryer against curtains and be sure to prevent items from falling or collecting behind the dryer. ● The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer.
INSTALLATION Electrical Requirements Tumble dryers are supplied to operate at a voltage of 230V, 50 Hz single phase. Check that the supply circuit is rated to at least 10A Electricity can be extremely dangerous. This appliance must be earthed. The socket outlet and the plug on the appliance must be of the same type. Do not use multiple adapters and/or extension leads. The plug should be accessible for disconnection after the appliance has been installed.
PREPARING THE LOAD Before using the tumble dryer for the first time: ● Please read this instruction book thoroughly. ● Remove all items packed inside drum. ● Wipe the inside of the drum and door with a damp cloth to remove any dust which may have settled in transit. Clothes Preparation Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Check that all fastenings are closed and that pockets are empty.
CONTROLS AND INDICATORS Water Tank Indicator Start/Pause Button Filter Care Indicator Progress Display Control Panel and Indicator Lights Delicates Button Delay Start Button Programme Selector SELECTING THE PROGRAMME Programme Selector – Select the required programme Delay Start button – Allows the user to delay the start of the drying cycle (see details of Operation on page 10) Start/Pause button – Press to commence the selected drying programme Delicates button – Press to reduce the heat level fo
SELECTING THE PROGRAMME PROGRAMME Bone Dry Extra Dry Cupboard Dry Iron Dry Wool Finish Relax DESCRIPTION Select the degree of dryness that you require. This ranges from for bath towels and bathrobes, through for items that will be put away without ironing, to the programme that leaves the laundry suitable for ironing. A gentle programme specially created to get woollens softer after air-drying.
DOOR and FILTER Opening the Door Pull on handle to open the door. To restart the dryer, close the door and press . WARNING! When the tumble dryer is in use the drum and door may be VERY HOT. Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Filter IMPORTANT: To maintain the efficiency of the dryer check that the fluff filter is clean before each drying cycle. 1.Pull the upwards. filter 2. Open filter as shown.
CONDENSER Important: Always switch off and remove the plug from the electricity supply before cleaning the condenser. To maintain the efficiency of the dryer regularly check that the condenser is clean. To Remove the Condenser 1.Remove kickplate. the 2. Turn the two locking levers anti-clockwise and pull out the condenser. 3.Pull out condenser unit. the 4.
OPERATION Delay Start Function The Delay Start Function allows the user to delay the start of the drying cycle by 3, 6 or 9 hours. When the function is first selected the display will show a delay of 3 hours, subsequent presses of the button will increase the delay to 6 or 9 hours. To commence the programme press and the appliance will complete the drying cycle at the end of this time. The 3, 6 or 9 hour indicator light will flash to indicate that the start delay is in progress.
TROUBLESHOOTING What Might be the Cause of... Defects you can remedy yourself Before calling GIAS Service for technical advice please run through the following checklist. A charge will be made if the machine is found to be working or has been installed incorrectly or used incorrectly. If the problem persists after completing the recommended checks, please call GIAS Service, they may be able to assist you over the telephone.
