EN User instructions GO W496D-AUS
Introduction Contents Please read these instructions for use carefully and all other information enclosed with the washing machine. Keep all documentation in a safe place for future reference or for any future owners.
General delivery notes Please check that the following items are delivered with the appliance: - Instruction manual - Certificate of guarantee - Inlet hose - Liquid detergent or liquid bleach compartment Check that no damage has occurred during transit, and if so, call your nearest Authorised Technical Support Service agent. N) If the appliance is not running properly or breaks down, switch it off, turn off the tap and do not tamper with the appliance.
KG Detector Description of controls IB L O Available on the Cottons and Synthetics cycles, the intelligent sensor adjusts the water level and programme length throughout each phase of the cycle according to how much laundry you load into the machine. The KG Detector indicator will light up when the intelligent sensor is weighing the laundry. M P D E F G H C N A The washing machine is fitted with a self-adjusting water level system.
“START/PAUSE” button C Press to start the selected cycle . After selecting the programme and the required options press the Start Pause button once to start the wash cycle. There will be a short time delay to the start of the programme while the machine sets the wash parameters for the selected programme and options. The Door Locked and KG Detector indicator lights will also illuminate a few seconds after pressing the Start Pause button.
H The spin cycle is very important to remove as much water as possible from the laundry without damaging the fabrics. You can adjust the spin speed of the machine to suit your needs. By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. To reactivate the spin cycle press the button until you reach the spin speed you would like to set.
6 3 { 2 M “STAIN LEVEL” button 8 { { 5 { 4 { 7 1 By selecting this button (active only on COTTON and MIXED FIBRES programmes) there is a choice of 3 levels of wash intensity, depending on how much the fabrics are soiled. Once the programme has been selected the indicator light will automatically show the stain level set for that programme. Selecting a different stain level the relevant indicator will light up.
TABLE OF PROGRAMMES PROGRAMME SELECTOR ON: PROGRAM FOR: WEIGHT RECOMMENDED MAX TEMP. kg °C MAX TEMP. °C CHARGE DETERGENT 2 Resistant fabrics 1) 1 8 60° Up to: 90° ● ● 8 40° Up to: 60° ● ● 4 40° Up to: 60° ● ● Very delicate fabrics 2,5 40° Up to: 40° ● ● “MACHINE WASHABLE” woollens 2 40° Up to: 40° ● ● Information for the test laboratories (Ref.
Programme selector For the various types of fabrics and various degrees of dirt the washing machine has different programme bands according to: wash cycle, temperature and lenght of cycle (see table of washing cycle programmes). COTTONS The Cotton programme includes a Prewash cycle. This option is particularly useful for really dirty loads and can be used independently of the main wash programme.
DRYING Note: Dispensers used for concentrated powders and liquid detergents must be removed from the drum before commencing the tumble drying programmes. The drum changes direction during the drying cycle to prevent the laundry from tangling and hence produce even drying. Cool air is used during the last ten minutes of the drying cycle to minimise creasing. LOW HEAT Low temperature drying programme for synthetics and mixed fibres, always refer to the care label.
Dosages Detergents, washing aids and amounts to use Choice of detergent General purpose detergents - - Powder detergents, for a thorough wash, with bleaching agent, particularly suitable for use in hot wash programmes (60°C and over), for heavily soiled and stained laundry. Liquid detergents, particularly suitable for grease stains, such as greasy skin marks, cosmetics and oil. These detergents are not suitable for washing stained laundry, as they do not contain bleach.
Useful advice for users Main wash Sorting the laundry - It is recommended you wash only items which are machine washable with water and detergent and not dry-clean items. - If you need to wash rugs, bedspreads or other heavy items, it is best not to spin them.
The correct way to wash DRYING Preparing the laundry A) Select the laundry. To minimize the risk of fire in a tumble dryer, the following should be observed: Loading the laundry B) Open the porthole. C) Put the laundry in the washing machine. Close the porthole again, ensuring that no items of laundry are obstructing the lock. Putting detergent in machine D) Open the drawer, choose the detergent and put in the correct amount, according to the manufacturer’s instructions and the advice on page 20.
IMPORTANT: THIS DRYER CAN ONLY BE USED FOR LAUNDRY WHICH HAS BEEN WASHED AND SPIN DRIED. Automatic washing/drying Warning: only a maximum 5 kg of dry laundry can be loaded otherwise the dried laundry will be not satisfactory. WASHING: Open the drawer, choose the detergent and put in the correct amount. Refer to the list of washing programmes according to fabrics to be washed (e.g.
Drying cycle The correct way to dry: - Open door. - Fill with up to 5 kg - in case of large items (e.g. sheets) or very absorbent items (e.g. towels or jeans), it is a good idea to reduce the load. - Close door. - Turn programme dial to cotton. Select the degree of dryness that you require. This ranges from Extra Dry ( ) for bath towels and bathrobes, through Cupboard Dry ( ) for items that will be put away without ironing, to iron dry ( ) that leaves the laundry suitable for ironing.
Cleaning and routine maintenance Do not use alcohol-based scourers and / or thinners on the outside of your washing machine, just a wipe with a damp cloth will suffice. The washing machine needs very little maintenance: - Cleaning the drawer compartments. - Cleaning the filter. - Cleaning the door glass. Cleaning the drawer compartments Even if it is not strictly necessary, it is good to clean the compartments for bleaching detergents and additives occasionally.
Investigating malfunctions What might be the cause of… Defects you can remedy yourself MALFUNCTION CAUSE REMEDY 1. Does not work on any programme Plug not in socket. Not switched on. Power failure. Fuse blown. Door open. Plug it in. Switch on. Check. Check. Close door. 2. Does not fill with water See cause 1. Tap turned off. Programme selector not correctly positioned. Fill hoses are kinked Check. Turn on tap. Position programme selector correctly. Straighten fill hoses 3.
SETTING UP + INSTALLATION 1 Remove the polystyrene base and place the machine near its permanent position (diagram 1). Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2). Remove the 3 fixing screws marked (A) and remove the 3 spacers marked (B) (diagram 3). 2 Remove the screw (C). A spacer will fall inside the machine. By tilting the machine, remove the above mentioned spacer. Cover the 4 holes using the caps provided in the instruction booklet pack (diagram 4). Fig.
Note: we recommend you keep the screws to immobilise the machine for future transit. The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation. Note: it is advisable to turn off the tap after each wash to isolate the washing machine from the water supply.
The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste.
