EN
Thank-you for choosing a Candy washing machine. We are confident it will loyally assist you in safely washing your clothes, even delicates, day after day. Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used).
l This appliances is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments. A different use of this appliance from household environment or from typical housekeeping functions, as commercial use by expert or trained users, is excluded even in the above applications.
l To consult the product fiche please l In the event of fault and/or malfunction, turn off the washing machine, close the water faucet and do not tamper with the appliance. Immediately contact the Customer Service Centre and only use original spare parts. Failure to observe these instruction may jeopardise appliance safety. refer to the manufacturer website. Safety instructions l Before cleaning or maintaining the washing machine, unplug the appliance and turn off the water faucet.
l Cut the tube straps, being careful EN 2. INSTALLATION 1 not to damage the tube and power cord. A B A B l Unscrew the 2 or 4 screws (A) on the back and remove the 2 or 4 shims (B) as illustrated in figure 1. B B A A l Close the 2 or 4 holes using the plugs included in the instruction envelope. l If the washing machine is built-in, 2 after cutting the hose straps, unscrew the 3 or 4 screws (A) and remove the 3 or 4 shims (B).
Hydraulic connections 3 l Connect the water tube to the faucet, only using the drain tube supplied with the washing machine (fig. 3). DO NOT OPEN THE FAUCET. l Some models may include one or more of the following features: 4 l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water faucet and the red one to the hot water faucet.
l Level the appliance using the feet as EN 8 illustrated in figure 8: a. turn the nut clockwise to release the screw; b. rotate the foot to raise or lower it until it adheres to the floor; c. lock the foot, screwing in the nut, until it adheres to the bottom of the washing machine. l Plug in the appliance. A B WARNING: contact the Customer Service Centre should the power cord need replacement.
Is a hot wash required? 3. PRACTICAL TIPS l Pretreat stains with stain remover or soak Load tips dried in stains in water before washing to reduce the necessity of a hot wash programme. Save up to 50% energy by using a 60°C wash programme. WARNING: when sorting laundry, make sure: Following is a quick guide with tips and recommendations on detergent use at the various temperatures. In any case, always read the instructions on the detergent for correct use and doses.
EN 4. MAINTENANCE AND CLEANING To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. The washing machine does not require any special care for ordinary cleaning: clean drawer compartments and the filter; some tips on how to move the machine or on long periods of disuse are provided below. Drawer cleaning S u g g e s tio n s fo r m o v e s o r prolonged disuse l We recommend you clean the drawer to avoid accumulating additive residue.
5. QUICK USER GUIDE This washing machine automatically adapts the level of the water to the type and quantity of washing. This system gives a decrease in energy consumption and a sensible reduction in washing times. 6. CONTROLS AND PROGRAMS A Program selection l Turn on the washing machine and select the required program. M l Adjust the washing temperature if necessary and press the required "option" buttons. washing.
When the START/PAUSE button has been pressed, the appliance can take few seconds before it starts working. A special safety device prevents the door from being opened immediately after the end of the cycle. Wait for 2 minutes after the wash cycle has finished and the "Door Security" light has gone out before opening the door.
button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero. - Confirm by pressing the START/PAUSE button (the light on the display starts to flash). The countdown will begin and when it has finished the programme will start automatically. SPIN SELECTION button l By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled.
l When a programme is selected the display automatically shows the cycle duration, which can vary, depending on the options selected. The display’s indicator system allows you to be constantly informed about the status of the machine. l Once the programme has started you will 2 be kept informed constantly of the time remaining to the end of the wash.
Table of programmes 2 TEMP.°C kg * (MAX.) PROGRAM 1) Recommended Max.
( ) (Only for models with liquid detergent compartment) When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine. Pour the bleach into the liquid bleach container, inserted into the compartment marked "2" in the detergent drawer, and set the special programme RINSE.
Programmes selection To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). Rapid Washing cycle suggested for low loads and slightly dirty. With this program it is recommended to reduce the quantity of detergent normally used, in order to avoid unnecessary waste. Selecting the RAPID program and acting on the button you can choose one of three programs available.
If you believe the washing machine is not working correctly, consult the quick guide provided below with some practical tips on how to fix the most common problems. Problem Possible causes and practical solutions The washing machine does not work/start Make sure it is correctly plugged in. Make sure power is on. Check whether the required program was correctly selected and to have correctly started the machine.
The use of ecological detergents without phosphates may cause the following effects: Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The warranty certificate must be duly filled in and stored, so as to be shown to the Authorised Candy Service Centre in case of need. - cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency.
fkhldsk
- GVD (5÷8) - 15.
