EN
Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. 1. GENERAL SAFETY RULES l This appliances is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments.
installation, the appliance l Do not expose the washing must be positioned so that the machine to rain, direct sunlight plug is accessible. or other weather elements. Protect from possible freezing. l The maximum load capacity of dry clothes depends on the l When moving, do not lift the model used (see control panel). washing machine by the knobs or detergent drawer; during l To consult the product technical transport, never rest the door on specification please refer to the the trolley.
2. INSTALLATION l Release the power chord and drain hose from the securing clip at the rear of the machine. l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections 3 EN l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l Some models may include one or more of the following features: l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
l Level the appliance using the feet as 8 illustrated in figure 8: a. turn the nut clockwise to release the screw; b. rotate the foot to raise or lower it until it touches to the floor; c. lock the foot, screwing in the nut, until it tightens against to the bottom of the washing machine. l Plug in the appliance. A B WARNING: contact the Customer Service Centre should the power cord need replacement.
l Pretreat stains with stain remover or soak Load tips dried in stains in water before washing to reduce the necessity of a hot wash programme. Save up to 50% energy by using a 60°C wash programme. WARNING: when sorting laundry, make sure: - have eliminated metallic objects such as hair clips, pins, coins, from laundry; Following is a quick guide with tips and recommendations on detergent use at the various temperatures.
l Remove and clean the filter; when 4. MAINTENANCE AND CLEANING To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. To maintain a good wash performance we recommend that the soap drawer and pump filters are regularly cleaned. A monthly service wash, using a proprietary cleaner is also recommended. finished, replace it turning it clockwise. The filter handle will be locked when it is not possible to turn any further and the handle is horizontal.
6. CONTROLS AND PROGRAMS This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. EN 5. QUICK USER GUIDE M A Program selection l Turn on the washing machine and select the required program. L l Adjust the washing temperature if necessary and press the required "option" buttons. I B l Press the START/PAUSE button to start washing.
START/PAUSE button WARNING: Don’t touch the display while inserting the plug because the machines calibrates the systems during the first seconds: touching the display, the machine couldn’t work property. In this case, remove the plug and repeat the operation. Close the door BEFORE selecting the button START/PAUSE. l Press to start the selected cycle. When the START/PAUSE button has been pressed, the appliance can take few seconds before it starts working.
l To delay the start use the following - AQUAPLUS procedure: programmes) allows you to wash the load in a much larger quantity of water and this, together with the new combined action of the drum rotation cycles, where water is filled and emptied, will give you garments which have been cleaned and rinsed to perfection so that the detergent dissolves completely, ensuring an efficient cleaning action. - Select the required programme.
- STAIN LEVEL button l Once the programme has been selected the wash time set for that programme will be automatically shown. l This option allows you to choose between 3 levels of wash intensity modifying the length of the programme, depending on how much the fabrics are soiled (can only be used on some programmes as shown in the table of programmes). TEMPERATURE SELECTION button l This button allows you to change the temperature of the wash cycles.
3) WASH TEMPERATURE LIGHTS The display’s indicator system allows you to be constantly informed about the status of the machine. This shows the washing temperature of the selected programme that can be changed (where allowed) by the relevant button. If you want carry out a cold wash all the indicators must be off. 3 1 2 7 8 4 10 5 6 INDICATOR 4) CYCLE DURATION l When a programme is selected the display automatically shows the cycle duration, which can vary, depending on the options selected.
l For all the information about the functionality and the instructions for an easy configuration of the Wi-Fi, please refer to the "Download" section on http://simplyfiservice.candy-hoover.com. l Through every wash phase "Kg Check" allows to monitor information on the wash load in the drum and in the first minutes of the wash it: - adjusts the amount of water required; 9) STEAM INDICATOR LIGHT - determines the length of the wash cycle; The indicator light shows the selection of the relevant option.
Place your smartphone so that the NFC antenna on its back matches the position of the SMART Fi+ logo on the appliance. This appliance is equipped with SMART Fi+ technology that allows you to control it remotely via App, thanks to Wi-Fi function. MACHINE ENROLLMENT (ON APP) l Download the Candy simply-Fi App on your device. The Candy simply-Fi App is available for devices running both Android and iOS, both for tablets and for smartphones.
Table of programmes 1) (MAX.) * PROGRAMME 2 (see control panel) (MAX.) EcoMix 20° 2) 4) 7 8 9 10 11,5 13 20° Coloured 40° 2) 4) 4,5 5,5 6 6,5 8 8 40° 4,5 5,5 6 6,5 8 8 60° 2,5 3 3 3,5 4 4 60° 1 1,5 1,5 1,5 2 2 30° 30' 2,5 2,5 2,5 2,5 3 3 30° 44' 3,5 3,5 3,5 3,5 4 4 40° Baby Care 4) Daily 59 Min. 14' 3) Rapid 14/30/44 Min.
(Only for models with liquid detergent compartment) When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine. Pour the bleach into the liquid bleach container, inserted into the compartment marked "2" in the detergent drawer, and set the special programme RINSE.
Programmes selection To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). EcoMix 20° This innovative programme, allows you to wash different fabrics and colours together, such as cottons, synthetics and mixed fabrics at only 20°C and provides an excellent cleaning performance. Consumption on this program is about 40% of a conventional 40°C. cottons wash.
Whites Made to have a perfect washing. The final spin at maximum speed gives more efficient removal. Easy Iron This wash program is suitable for mixed fabrics and uses a steam treatment that relaxes creases and regenerate fibres, which makes ironing the garment far easier. 21 SMART Fi+ Position that you have to select when you want to enable remote control through the App (via Wi-Fi). In this case, the start of cycle will take place through the App commands.
7. THROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. ERROR CODE FORMAT l Models with a display: the error is shown by a number preceded by the letter “E” (example: E2 = Error 2). l Models without display: an error is shown by a sequence of flashes of every LED.
Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
The use of ecological detergents without phosphates may cause the following effects: - cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency. If the problem persists or if you suspect a malfunction, immediately contact an Authorised Customer Service Centre. It is always recommended to use original spare parts, that are available at our Authorised Customer Service Centres.
WIRELESS PARAMETERS (for model with Wi-Fi function) (for model with NFC function) Parameter Wireless Standard Frequency range Max Trasmit Power Parameter Specifications 802.11 b/g/n 2.412 GHz. - 2.484 GHz. 802.11b (11Mbps) +18,5 ± 2 dBm Wireless Standard Frequency band 802.11g (54Mbps) +16 ± 2 dBm Magnetic field limit 802.11n (HT20, MCS7) +14 ± 2 dBm 802.11b (11Mbps) -93 dBm Minimum Receiving Sensitivity Specifications ISO/IEC 14443 Type A and NFC Forum Type 4 13.553-13.
fkhldsk
fkhldsk
- GVF TH (7÷13) - 17.
