EN
Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. 1. GENERAL SAFETY RULES l This appliances is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments.
installation, the appliance l Do not expose the washing must be positioned so that the machine to rain, direct sunlight plug is accessible. or other weather elements. Protect from possible freezing. l The maximum load capacity of dry clothes depends on the l When moving, do not lift the model used (see control panel). washing machine by the knobs or detergent drawer; during l To consult the product technical transport, never rest the door on specification please refer to the the trolley.
2. INSTALLATION l Release the power chord and drain hose from the securing clip at the rear of the machine. l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections 3 EN l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l Some models may include one or more of the following features: l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
l Level the appliance using the feet as 8 illustrated in figure 8: a. turn the nut clockwise to release the screw; b. rotate the foot to raise or lower it until it touches to the floor; c. lock the foot, screwing in the nut, until it tightens against to the bottom of the washing machine. l Plug in the appliance. A B WARNING: contact the Customer Service Centre should the power cord need replacement.
l Pretreat stains with stain remover or soak Load tips dried in stains in water before washing to reduce the necessity of a hot wash programme. Save up to 50% energy by using a 60°C wash programme.
l Remove and clean the filter; when 4. MAINTENANCE AND CLEANING To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. To maintain a good wash performance we recommend that the soap drawer and pump filters are regularly cleaned. A monthly service wash, using a proprietary cleaner is also recommended. finished, replace it turning it clockwise. The filter handle will be locked when it is not possible to turn any further and the handle is horizontal.
6. CONTROLS AND PROGRAMS This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. EN 5. QUICK USER GUIDE Q A Program selection l Turn on the washing machine and select the required program. I l Adjust the washing temperature if necessary and press the required "option" buttons. LMNO P H l Press the START/PAUSE button to start washing.
l Press to start the selected cycle. Opening the door When the START/PAUSE button has been pressed, the appliance can take few seconds before it starts working. A special safety device prevents the door from being opened immediately after the end of the cycle. Wait for 2 minutes after the wash cycle has finished and the "Door Security" light has gone out before opening the door.
- EASY IRON This function allows you to minimizes creases as much as possible, eliminating the intermediate spins or reducing the intensity of the last one. - Confirm by pressing the START/PAUSE button. The delay countdown will begin and when it has finished the programme will start automatically. If an option is selected that is not compatible with the selected programme then the option indicator light first flashes and then goes off.
l The key lock can be simply cancelled by SPIN SPEED button l By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. l If the label does not indicate specific information, it is possible to use the maximum spin expected in the program. To prevent damage to the fabrics, it is not possible to increase the speed over the maximum allowed for the programme. pressing the two buttons simultaneously again or turning off the appliance.
l When START/PAUSE 5) KEY LOCK INDICATOR LIGHT The indicator light show that the keys are locked. If the door is not properly closed, the light will continue to flash for about 7 seconds, after which the start command will be automatically cancelled. In this case, close the door in the proper way and press the START/PAUSE button. 6) WASH TEMPERATURE LIGHTS INDICATOR This show the washing temperature of the selected programme that can be changed (where allowed) by the relevant button.
l Smart Care – Smart Check-up and Auto- SMART TOUCH Clean cycles and a troubleshooting guide. This appliance is equipped with Smart Touch technology that allows you to interact, via the App, with smartphones based on Android operating system and equipped with NFC (Near Field Communication) function. l Download on your smartphone Candy simply-Fi App. the The Candy simply-Fi App is available for devices running both Android and iOS, both for tablets and for smartphones.
If you do not know the position of your NFC antenna, slightly move the smartphone in a circular motion over the Smart Touch logo until the App confirms the connection. In order for the data transfer to be successful, it is essential TO KEEP THE SMARTPHONE ON THE DASHBOARD DURING THESE THE FEW SECONDS OF THE PROCEDURE; a message on the device will inform about the correct outcome of the operation and advise you when it is possible to move the smartphone away.
Table of programmes 1) (MAX.) * 2 (see control panel) PROGRAM (MAX.) Whites Cottons + Prewash 2) 5 6 7 8 9 10 11 12 90° 5 6 7 8 9 10 11 12 60° 5 6 7 8 9 10 11 12 20° 5 6 7 8 9 10 11 12 60° 2,5 3 3,5 4 4,5 5 5,5 6 60° 1,5 2 2,5 3 3 3,5 3,5 4 60° 1 1,5 1,5 1,5 1,5 2 30° 30' 1,5 2 2,5 2,5 2,5 2,5 2,5 3 30° 44' 40° 2) EcoMix 20° ** 2) Synthetics 1 2) Daily 59 Min. 14' 1 1 2 1 3) Rapid 14/30/44 Min.
Please read these notes: * Maximum load capacity of dry clothes, according to the model used (see control panel). ** STANDARD COTTON PROGRAMMES ACCORDING TO (EU) No 1015/2010 and No 1061/2010. COTTON PROGRAMME TEMPERATURE OF 60°C. WITH A COTTON PROGRAMME TEMPERATURE OF 40°C. WITH A These programmes are suitable to clean normally soiled cotton laundry and they are the most efficient programmes in terms of combined energy and water consumptions for washing cotton laundry.
Programmes selection To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). Whites An intensive wash. The final spin at maximum speed gives more efficient removal. Cotton + Prewash This programme has been designed to remove the stronger stains from cotton white clothes. The prewash guarantees the tough dirt removal.
to clean the drum, remove bad smells and extend the life of the washing machine. Make sure there is no load in the drum before starting the "Auto-Clean" cycle, use a proprietary washing machine cleaning agent or powder detergent. Leave the door of the machine open at the end of the cycle to allow the drum to dry. Recommended every 50 washes.
7. THROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. FOR SMART TOUCH MODELS The Candy simply-Fi app has a Smart Check-up function that allows you to confirm the functionality and status of the product at any time. To use the Candy simply-Fi app you will need an Android smartphone with NFC technology. More info can be found on the App.
Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
The use of ecological detergents without phosphates may cause the following effects: - cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency. If the problem persists or if you suspect a malfunction, immediately contact an Authorised Customer Service Centre. It is always recommended to use original spare parts, that are available at our Authorised Customer Service Centres.
fkhldsk
fkhldsk
fkhldsk
- GVSD (5÷12) - 16.