EN
Thank you for choosing this product. We are proud to offer the ideal product for you and the best complete range of home appliances for your daily routine. WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
l This appliance is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments. A different use of this appliance from household environment or from typical housekeeping functions, as commercial use by expert or trained users, is excluded even in the above applications.
Electrical connections safety instructions l Do not expose the washing machine to rain, direct sunlight or other weather elements. Protect from possible freezing. and l The technical details (supply voltage and power input) are indicated on the product rating l When moving, do not lift the washing machine by the knobs plate or detergent drawer; during l Make sure that the electrical transport, never rest the door on system is earthed, complies the trolley.
l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections 3 l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l SOME MODELS may include one or more of the following features: 4 l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
Setting 7 EN l The washing machine should be installed in its final position such that the water fill hose is not kinked or trapped. The corrugated drain hose should be inserted into suitable drain pipe of between 50 cm and 85 cm height above the floor using the curved drain hose support. If an under sink connection is used the drain hose must be routed above the sink overfill opening to prevent back siphoning. Care must be taken to avoid kinking or trapping the drain hose (fig. 7).
3. DETERGENT DRAWER The detergent draw is split into compartments as illustrated in figure 9: 3 9 l compartment "1": for prewash detergent; l compartment “ ”: for special additives, 1 softeners, starch fragrances, etc.; 2 WARNING: only use liquid products; the washing machine is set to automatically dose additives at each cycle during the last rinse. l compartment "2": for 10 washing detergent. A liquid detergent cup is also included IN SOME MODELS (fig. 10).
Maximise the load size 4. PRACTICAL HINTS detergent and time by using the recommended maximum load size. Save up to 50% energy by washing a full load instead of 2 half loads.
The use of ecological detergents without phosphates may cause the following effects: When washing heavily soiled whites, we recommend using cotton programs of 60°C or above and a normal washing powder (heavy duty) that contains bleaching agents that at medium/high temperatures provide excellent results. - cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency.
l Fill the drawer with hot water. EN 5. CLEANING AND MAINTENANCE Looking after your appliance correctly can extend its lifespan. Cleaning the appliance’s exterior l Disconnect the machine from the power supply. l Clean the appliance’s external cabinet, using a damp cloth and AVOIDING ABRASIVES, ALCOHOL AND/OR DILUENTS. Drawer cleaning l Shake the drawer in order to let the water l It is advisable to regularly clean the flow in all the compartments.
Cleaning the pump filter l The appliance has a special filter that traps larger residues that could block the draining system, such as buttons or coins (depending on the model, consider version A or B). We recommend checking and cleaning the filter 5 or 6 times a year. l Disconnect the machine from the power supply. l Ensure all the water has been emptied from the drum. l Before unscrewing the filter, we recommend you place an absorbent cloth under it to keep the floor dry.
7. COMMAND PANEL B E The Candy Nova line of appliances is entirely designed to be used remotely, directly through your smartphone. With the help of the new hOn App, which can be downloaded from Google Play (or HUAWEI AppGallery) if you have an Android device, or from the App Store if you have an Apple device, you will be able to manage your appliance remotely, with a simple click.
8. APPLIANCE LED STATUS LEGEND APPLIANCE STATUS LED COLOUR OFF/Stop Off ON/Waiting for cycle selection (Remote control disabled) Slow fade (green) ON/Cycle running (Remote control disabled) Fixed (green) ON/Waiting for cycle selection (Remote control enabled) Slow fade (blue) ON/Cycle running (Remote control enabled) Fixed (blue) "Pairing the App"/ Reset Wi-Fi mode Quick flashing 0.2s on (blue) 0.2s off Error Flashing pattern 0.5s blue 0.
9. USER GUIDE X1 EN Switching on l Switch on the machine by pressing and holding for 4 seconds the ON/OFF button. D 20°C 1s 4s l Release the button when the green light starts flashing. X1 E 1s Green LED: Remote control disabled Select washing programme * DEFAULT: Mixed & Coloured 59', 20°C.
l After selecting the programme, the green For safety reasons, in some phases of the wash cycle, the door can only be opened if the level of the water is below the door’s lower rim and the temperature is below 45°C. If these conditions are met, you have to wait for 1 minute before you can open the door. LED on the on/off button on the command panel will start flashing. To confirm the selection and about 1 second after pressing on the "STAR" cycle button, you will hear a short acoustic signal.
INFORMATION FOR THE TEST LABORATORIES Programmes STANDARD PROGRAMMES ACCORDING TO (EU) No 1015/2010 e No 1061/2010 ECO 40-60 PROGRAMME SETTING THE TEMPERATURE TO 40°C ECO 40-60 PROGRAMME SETTING THE TEMPERATURE TO 60°C ________________________________________ STANDARD PROGRAMME ACCORDING TO (EU) No 2019/2023 ECO 40-60 PROGRAMME * DEFAULT: Mixed & Coloured 59', 20°C. Can be customised via the App (see the "STAR" cycle button paragraph). All the other programmes are available through the App.
The LED will turn green and start flashing slowly. 10. REMOTE CONTROL Pairing the App l Scan the following QR code to download the App onto your device: 4s or follow the link below: go.haier-europe.com/download-app l Press and hold the REMOTE CONTROL button for 4 seconds, until you hear the second acoustic signal (and release). The App is available both for Android and for iOS tablets and smartphones.
l Open the App and start the cycle. credentials of the home Wi-Fi network (name and password). l At the end, switch off the appliance by pressing and holding the ON/OFF button for 3 seconds. The door will unlock after about 1 minute. The frequency of your home Wi-Fi network must be in the 2.4 GHz band. The machine cannot be configured if the home network is set on the 5 GHz band.
l From now on, by pressing the "STAR" "STAR" CYCLE button The "STAR" cycle button can be used to start a washing cycle that can be customised through the App. The factory default cycle is Mixed & Coloured 59', 20°C, 1000 rpm. After pairing the product with the App, you can edit the programme saved in this position at any time, selecting it from the programme list. After saving the programme on the appliance, you can start it directly from the dashboard, like a normal cycle.
If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. Errors will be highlighted directly on the appliance via alternating flashing patterns of blue and green LED lights. 0.5s blue – 0.5s green flashing If the appliance has been correctly paired and is therefore connected to the App and to the Internet, a pop-up on the smartphone’s display screen will show the error code.
OTHER ANOMALIES Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The certificate has to be stored so as to be shown to the Authorized Customer Service Centre in case of need. You can also check the warranty conditions on our web site. To obtain assistance, please fill in the form on-line or contact us at the number indicated on the support page of our web site.
- WM NOVA - 20.12 - 43039643 - IDM s.r.l.
