EN HOBS 70 cm USER INSTRUCTIONS
TECHNICAL CHARACTERISTICS INSTALLATION Cooking hobs 70x50 Burners Reference type Supply Voltage (V/Hz) Installed electric power (W) Medium burner Large burner Small burner Double ring burner Maxi burner Fish burner Power of gas installed: - Natural gas 1,0 kPa (MJ/H)** - LPG gas 2,75 kPa (MJ/H) Electric ignition* Gas safety device Product size mm.
and 0,75 mm2 for others products. Also, the maximum external diameter of the cable should not be greater than 7 mm. Instructions for the installer Suitable location A gas-powered cooking appliance produces heat and himidity in the area in which it is installed. For this reason you should ensure good ventilation either by keeping all natural air passages open or by installing an extractor hood with an ehaust flue (Fig. 3-4).
Table of gas consumption Adapting the hob to different types of gas To adapt the Hob for use with different types of gas, carry out the following instructions: — remove the grids and burners — insert the hexagonal spanner (supplied) into the burner support (Fig. 5) — unscrew the injector and replace it with one suitable for the gas to be used (see Table page 6).
After the burner ignites, turn the knob to the control setting required. The ignition is by repetitive spark generation; in case the burner does not light at once, keep the knob in the ignition position for a maximum of 5 seconds. If the burner does not ignite in this time, switch off the control knob and repeat the operation again. As a safety device, some models automatically cut off the gas supply if the flame is accidently extinguished.
INSTRUCTIONS FOR ASSEMBLY OF THE HOB TO THE GAS SUPPLY PIPES Lubricating the gas taps If a gas tap becomes stiff, it should be dismantled, cleaned carefully with petrol and smeared with a drop of special heat resistant grease. The following operations should be carried but: — disconnect the electrical power supply, close the gas supply tap from the mains or cylinder. — Remove the hob top plate by removing the corner screws and those under the burners. — Remove the two screws holding down the head flange.
Grafica R.B. - 02/2002 - Cod.