Instruction Manual

ManualsBrandsCandy ManualsStovesPR 2250 GH

INSTALLATION

Instructions for the installer

The Purchaser is responsible for the installation of the hob. The Manufacturer does not

accept any responsibility for any damage or loss resulting from incorrect installation,

and as such this will not covered by the Manufacturer’s Guarantee.

The hob may be installed in any worktop which is heat resistant to a temperature of

100° C, and has a thickness of 25 - 40 mm. The dimensions of the insert to be cut out

of the worktop are in shown in Fig. 1.

If the Hob is fitted next to a cabinet on either side,

the distance between the Hob and the cabinet

must be at least 150 mm (see Fig. 2); while the

distance between the hob and the rear wall must

be at least 55 mm.

When there is an accessible space between the

built-in hob and the cavity below, a dividing wall

made of insulating material should be inserted

(wood or a similar material).

The wall should be at least 10 mm away from bot-

tom of the drawer. (fig. 2)

The Hob unit is fitted by attaching the Fixing Clamps supplied, using the holes at the base

of the unit.

Applying the sealant

Important - The diagram below shows how the sealant should be applied.

This appliance has been designed for non-professional, i.e. domestic, use.

Appropriate checks and tests have ensured that, even in the most extreme conditions,

the temperatures reached are within acceptable limits. The Hob is thermally insula-

ted (in line with Regulation EN) and may be installed: next to panels higher than

the worktop, for type «Y», or next to panels not higher than the worktop for type

«X». See technical characteristics table «Degree of protection».

Fig. 2

Partition panel

50 mm

min.

30 mm

10 mm

TECHNICAL CHARACTERISTICS

* Some models only ** Manufacturer setting IE cat. II2H3 + GB cat. II2H3 +

Cooking hobs 60x50 A A B B

Burners 4 gas 4 gas 3 gas 3 gas

– – 1 electric 1 electric

Reference type PL01 PL02 PL01 PL02

Supply Voltage (V/Hz) 230/50 230/50 230/50 230/50

Installed electric power (W) – – 1400 1400

Medium burner 1 1 – –

Large back burner 1 1 1 1

Small burner 1 1 1 1

Large front burner 1 1 1 1

Double ring burner – – – –

Maxi burner – – – –

Power of gas installed:

- G20/20 mbar (kW)** 8,2 8,2 6,7 6,7

- G30/28-30 mbar (g/h) 597 597 488 488

Electric ignition* yes yes yes yes

Gas safety device – yes – yes

Product size mm. 595x510 595x510 595x510 595x510

Degree protection – – Type Y Type Y

Class 3 3 3 3

Fig. 1

Fig. 1b

MD L