EN
Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. 1. GENERAL SAFETY RULES l This appliance is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments.
such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the washer dryer. never stop a washer dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. installation, the appliance l Fabric softeners, or similar products, should be used as must be positioned so that the specified by the fabric softener plug is accessible.
l To consult the product technical l Do not pull on the power cord specification please refer to the or appliance to unplug the manufacturer website. machine. Electrical connections safety instructions l Make sure there is no water in the drum before opening the door. and l The technical details (supply voltage and power input) are indicated on the product rating plate WARNING: water may reach very high temperatures during the wash cycle.
l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections 3 l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l SOME MODELS may include one or more of the following features: 4 l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
Setting 7 EN l The washing machine should be installed in its final position such that the water fill hose is not kinked or trapped. The corrugated drain hose should be inserted into suitable drain pipe of between 50 cm and 85 cm height above the floor using the curved drain hose support. If an under sink connection is used the drain hose must be routed above the sink overfill opening to prevent back siphoning. Care must be taken to avoid kinking or trapping the drain hose (fig. 7).
3. DETERGENT DRAWER The detergent draw is split into compartments as illustrated in figure 9: 3 9 l compartment "1": for prewash detergent; l compartment “ ”: for special additives, 1 softeners, starch fragrances, etc.; 2 WARNING: only use liquid products; the washing machine is set to automatically dose additives at each cycle during the last rinse. l compartment "2": for washing 10 detergent. A liquid detergent cup is also included IN SOME MODELS (fig. 10).
Load tips Before using a drying (WASHER-DRYERS) When sorting laundry, make sure: - have eliminated metallic objects such as hair clips, pins, coins, from laundry; programme l SAVE energy and time by selecting a high spin speed to reduce the water content in laundry before using a drying programme. - to have buttoned pillow cases, closed zips, tied loose belts and long robe ribbons; Following is a quick guide with tips and recommendations on detergent use at the various temperatures.
l Repeat the previous steps in reverse 5. CLEANING AND MAINTENANCE order to reassemble all parts. To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. To maintain a good wash performance we recommend that the soap drawer and pump filters are regularly cleaned. A monthly service wash, using a proprietary cleaner is also recommended. Drawer cleaning l We recommend you clean the drawer to avoid A B accumulating detergent and additive residue.
This appliance is equipped with Wi-Fi technology that allows you to control it remotely via App. * OFF MACHINE ENROLLMENT (ON APP) l Download the Candy simply-Fi App on your device. * REMOTE CONTROL (Wi-Fi) The Candy simply-Fi App is available for devices running both Android and iOS, both for tablets and for smartphones. TO DISABLE REMOTE CONTROL l To exit REMOTE CONTROL mode while Get all the details of the Wi-Fi functions by browsing the App in DEMO mode.
7. QUICK USER GUIDE This appliance automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. 8. CONTROLS AND PROGRAMS OFF 1000 Pre 800 600 400 Program selection A l Turn on the appliance and select the required program. I l Adjust the washing settings if necessary 1000 800 and select the required options.
parameters, press PLAY/PAUSE. When the programme is running, the display will show the time to elapse. Don’t touch the buttons while inserting the plug because the machines calibrates the systems during the first seconds: touching the buttons, the machine couldn’t work property. In this case, remove the plug and repeat the operation. l Moreover, If you want to modify the chosen program, press the desired options buttons, modify the default parameters and then press PLAY/ PAUSE button to start the cycle.
PAUSING THE MACHINE l Keep the PLAY/PAUSE button pressed for about 2 seconds (some light indicators and the residual time display will flash, showing that the machine is paused). - Confirm by pressing the PLAY/PAUSE button. The delay countdown will begin and when it has finished the programme will start automatically. l You can cancel the start delay by turning the SMART RING to the OFF position.
- HYGIENE + Activated when you set 60°C of temperature. This option allows deep cleaning of your clothes by maintaining the same temperature for the whole wash. l By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. l If the label does not indicate specific If an option is selected that is not compatible with the selected programme then the option indicator light first flashes and then goes off.
If a washing programme is not compatible with automatic drying is selected, this function will not be activated. If you exceed the maximum dryable load of laundry indicated in the programme table, the laundry may not be dried satisfactory. l To only perform a drying cycle: select the desired drying programme in conjunction with your fabrics, by pressing this button it is possible to select a degree of dryness that is different to the default one (except for the wool drying programme).
7) DRYING SELECTION INDICATOR LIGHTS The indicators display the degrees of dryness that can be selected by the relevant button: is pressed on the machine with the door closed, the indicator will flash momentarily and then illuminate. Automatic drying programmes If the door is not properly closed, the light will continue to flash for about 7 seconds, after which the start command will be automatically delete. In this case, close the door in the proper way and press the PLAY/PAUSE button.
Table of programmes 1) (MAX.) * PROGRAMME 2 (see control panel) (MAX.
INFORMATION FOR THE LABORATORIES (Ref. EN Standards) Washing Use the programme ** with the maximum degree of soiling selected, maximum spin speed and a temperature of 60°C. (Only for models with liquid detergent compartment) When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine.
Description of programmes To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). Choose programme in accordance with the laundry instructions appearing on labels, especially the maximum recommended temperature. WASHING DAILY 39' The perfect combination of time saving and performance. This programme provides an excellent wash for half a load of laundry in only 39 minutes.
WARNING: EN IMPORTANT WASH PERFORMANCE ADVICE. The wool drying cycle of this machine has been approved by "The Woolmark Company" for the drying of machine washable wool products provided that the products are washed and dried according to the instructions on the garment label and those issues by the manufacturer of this machine. l New, coloured garments should be washed separately for at least 5 or 6 washes. l Certain large dark items such as jeans and towels should always be washed separately.
9. DRYING CYCLE The correct way to dry l Drying guidance advice is general, but practical experience of using the product will help you to achieve the best drying results. l We recommend setting a lower drying time than indicated, when first using the appliance in order to establish the degree of dryness required. l We recommend not drying fabrics that fray easily, such as rugs or garments with a deep pile, in order to avoid air duct clogging.
the discharge correctly. hose is During the drying phase the drum will accelerate to a higher speed to distribute the load and to optimize the drying performance. positioned WARNING: In order to ensure the correct operation of the appliance, it is advisable not to interrupt the drying phase unless it is absolutely necessary. Do not dry articles with special padding (e.g. quilts, quilted anoraks, etc.) and very delicate fabrics. If garments are drip/dry, load less items to prevent creasing.
10. TROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. ERROR CODE FORMAT l Models with a display: the error is shown by a number preceded by the letter “E” (example: E2 = Error 2). l Models without display: an error is shown by a sequence of flashes of every LED.
Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
The use of ecological detergents without phosphates may cause the following effects: Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The certificate has to be stored so as to be shown to the Authorized Customer Service Centre in case of need. You can also check the warranty conditions on our web site. To obtain assistance, please fill in the form on-line or contact us at the number indicated on the support page of our web site.
Parameter Specifications (Wi-Fi) Specifications (Bluetooth) Wireless Standard 802.11 b/g/n Bluetooth v4.2 Frequency range 2,412 GHz. - 2,484 GHz. 2,412 GHz. - 2,484 GHz. 802.11b, DSSS 1 Mbps = +19.5 dBm Basic data Rate: RF Transmit Power (Typ): +4 dBm 802.11b, CCK 11 Mbps = +18.5 dBm Max Transmit Power 802.11g, OFDM 54 Mbps = +18.5 dBm 802.11n, MCS7 = +14 dBm 802.11b = 1024 bytes, -80 dBm 802.11g = 1024 bytes, Minimum Receiving Sensitivity -70 dBm 802.11n = 1024 bytes, -65 dBm 802.
fkhldsk
fkhldsk
- WD Rapidó - 19.