User guide

MAN 01/EN/01 CRONO S-PID 50 02/13

SECTION 5

In the event that it is not possible to remove the battery using the ribbon strap,

do not use an object to lever out the battery, but proceed as follows:

• Hold the pump and the compartment cover firmly in your right hand;

• Strike the palm of your other hand with the pump, to jolt the battery from the

compartment.

• The cover is supplied with a gasket which must remain in position as

indicated in the illustration.

BATTERY REPLACEMENT

Use a 3 Volt Lithium battery, model 123 A.

To replace the battery, ensure that the pump is switched off (the display

showing OFF or StoP), and then proceed as follows:

1. Open the cover of the battery compartment with the appropriate tool

supplied, or by using a paper clip

2. Pull back the cover

3. Use the small ribbon strap (which lies under the battery) to facilitate the

removal of the battery.

4. Remove the discharged battery and discard it properly, using the

appropriate containers.

5. Wait 10 seconds before insert the new battery checking that it is in the

correct position (see picture below) and that the ribbon strap is under the

battery.

6. After you have inserted the battery, close the compartment cover.

NOTES

Gasket