User guide

MAN 01/EN/01 CRONO S-PID 50 02/13

• The displayed error messages (from Er,2 to Er,11 and OCCL) are

accompanied by an acoustic signal and the system stops.

• To initialize the device, remove the battery when the pump is in an error

state or the ON state and reinsert it after 10/15 sec. If the error is detected

again after the corrective action or initialisation of the device, contact the

CANÈ S.p.A. Technical Support Service.

• Following the display of error message Er,8 and the successive initialisation,

the system reverts to the factory settings (see page 29): in this event the

pump settings prescribed by the doctor should be re-entered.

• Error messages Er,2 and Er,7 are accompanied by the flashing red LED.

WARNINGS

SECTION 7

NOTES