User guide

MAN 01/EN/01 CRONO S-PID 50 02/13

PUMP SETTINGS SEQUENCE WITH THE PUMP OFF CONDITION

When the device is set to OFF, the following parameters

can be set:

1 - End of infusion acoustic signal.

2 - Number of infusion sites (feature available only in flow

rate mode).

3 - Partial volume.

In the OFF state, the parameters can only be selected in

the following conditions:

- Settings lock unlocked

- At the start of a new infusion (partial or total).

To access the settings, press the

button for about

3 seconds: the display shows the setting of end of infusion

acoustic signal. You can change the parameter setting

(activate/de-activate) while the display is flashing using the

and buttons.

Press the button once more and

the display will show

and allow setting the number of infusion sites (IP =

Infusion Point). You can change the parameter setting

(activate/de-activate) while the display is flashing using the

and buttons.

Press the

button again to display and set the partial

volume. You can change the parameter setting (activate/

de-activate) while the display is flashing using the

and

buttons.

When the settings lock is on (L 1), if any attempts are made to change the

parameter then the display will show the flashing lock symbol and beep

several times.

NOTE

SECTION 10

PROG