User guide

MAN 01/EN/01 CRONO S-PID 50 02/13

This function is active only if the pump has been set in flow rate mode.

In case it is required to administer a drug volume by dividing it in multiple

infusion sites, called Infusion Points (IP), the pump allows you to select up to

5 sites and make partial delivering in succession.

To set this parameter, press the button again.

You can select the number of infusion sites IP (while the number of sites is

flashing) in which the drug volume is to be administered; the selection is done

using the

and buttons; select the number of sites from 1 to 5:

- Select 1 to administer the drug contained in the syringe at one single

infusion site;

- Select 2 to administer 50% of the drug contained in the syringe at one site

and then, the other 50% at another infusion site;

- Select 3 to administer the drug contained in the syringe at 3 different infusion

sites (33% at each site) and so on. Select 4 (25% at each site) and 5 (20%

at each site).

SETTING THE NUMBER OF INFUSION SITES

1 - The first fraction of the drug volume contained in the

syringe will be administered at one infusion site. Then,

the pump will stop and the display will show End, and

it will emit, at the same time, an intermittent acoustic

signal indicating the end of partial infusion until the start

of the next fraction.

2 - Then, the display will show End alternating with 1-4

(fraction 1 out of 4 administered).

SECTION 10

By selecting a number of infusion sites from 2 to 5, for example 4, the pump

will run the administration as follows: