User guide

MAN 01/EN/01 CRONO S-PID 50 02/13

3 - In this phase, the patient can replace the infusion set,

start the pump again by pressing the button, perform

the priming, change the infusion site and continue with

the infusion.

4 - The pump will proceed in the same manner described

above with the next infusion sites, showing End

alternating with 2-4, End alternating with 3-4 and

eventually End. Dosing of infusions will end and the

pusher will be withdrawn to the infusion start position.

• The function is available only if the pump is programmed according to flow

rate mode “F”.

• At the start of the administration of each Infusion Point the priming function

is available again.

• At the end of the administration of each Infusion Point the device emits

an intermittent acoustic signal which can be switched off by pressing the

button.

NOTES

Using aspiration with a normal syringe, verify that the needle is not inserted

into a vein or a capillary at every change of the infusion site (refer to your

general practitioner for more information on the procedure to be used).

WARNING

SECTION 10