User guide

43
MAN 01/EN/01 CRONO S-PID 50 02/13
SECTION 10
SWITCHING ON THE PUMP
From the OFF state, press the button. The pump will
give a brief beep and display:
• Pr (priming function) the display shows Pr. There are three
options (see page 44);
• Having carried out the priming, or if the pump is turned
on to resume the infusion from the StoP state, the display
shows the following in sequence:
- The partial volume value (if it has been set)
- The number of infusion sites (in flow rate mode only)
- The value of delivery time or flow rate
When the pump is in action, the display shows the flow rate
value in ml/h or the delivery time in hours and/or minutes:
• From 500 h to 100 h the delivery time decreases
hour by hour
• From 99.59 h to 1 minute the delivery time decreases
minute by minute.
THE PUMP IN ON CONDITION
Before starting an infusion:
• Inspect the infusion line to ensure there are no folds, clamps or other
occlusions in the line
• Expel any air bubbles.
WARNINGS
ml/h