User guide

MAN 01/EN/01 CRONO S-PID 50 02/13

SWITCHING OFF THE PUMP

To switch off the pump during an infusion, press the and

the

buttons simultaneously; the display will show StoP.

If the pump is switched off during an infusion, the device

will emit a series of 10 short beeps every 10 seconds, and

the display will flash the StoP message. To interrupt the

audible signals, press the

button. These indications will

be repeated each time the pump is switched off during an

infusion.

DISPLAYING THE SETTINGS

The procedure is as follows (pump in flow rate mode):

1. Press the button for approx. 1 second: the display will

show the menu for selecting the end of infusion alarm.

2. Press the button for approx. 1 second: the display

shows the number of infusion sites.

3. Press the button again and the display will show the

selected partial volume.

4. Do not press any button for 9 seconds, and the setting

phase will end. The display will show OFF or StoP.

SECTION 10

This function displays the settings of the pump from when it was programmed.

To display the pump settings, the pump must be set to OFF or StoP.

If the settings are displayed when the settings lock is set to L 0 (settings lock

off) the settings flash and can be modified. If the settings are displayed when

the settings lock is set to L 1 (settings lock on, with the display showing the

"lock" symbol), the settings do not flash and cannot be modified.