User guide

30
MAN 01/EN/03 CRONO PAR 50 06/13
SECTION 8
SELECTING THE PUMP MODE
PUMP INITIALISATION
1. runs a self-diagnosis test, emitting a series of brief acou-
stic signals, ashing the red LED and displaying all the
indicators and icons on the screen;
2. displays OFF at the end of the preceding operation.
• The pump is supplied with a new battery already inside the pump.
• To initialise the device, remove the battery and reinsert it after 10/15 secon-
ds. If the error is detected again after the corrective action or initialisation of
the device, contact the CANÈ S.p.A. Technical Support Service.
• For instructions on how to install the battery, see page 21.
• You are recommended to initialise the pump if it is left unused for a long
period (more than 1 - 2 months) and the battery is not removed.
• If, after the insertion of the battery (initialisation of the pump) the display
does not indicate the above-mentioned information, you are recommended
to remove and re-insert the battery.
NOTES
The CRONO PAR 50 pump offers, in a single body, two programming modes
called FrEE and Auto, to satisfy different therapeutic needs.
FrEE is a mode with basic functions that allows the patient to freely select,
during the day, one of the 3 available ow rates pre-programmed by the doctor,
the bolus dose and the drug volume contained in the reservoir.
Auto is a mode with advanced functions which allows you to program different
ow rates over the daily 24-hour period, as well as other functions described
below.
When you insert the battery, the pump runs the initialisation sequence, during
which it: