User guide

MAN 01/EN/03 CRONO PAR 50 06/13

Auto

SETTING THE TIME

Proceed as follows:

1. with the pump set to either the OFF or StoP conditions,

press the

button for about 4 seconds: the display shows

the time;

Pressing the

button enables the setting of the time: the

hour value begins to ash.

2. press the

button to increase the value; press the

button to decrease it. Each change in value is indicated by

a brief beep;

3. do not press any button for 20 seconds, and the setting

phase will end. The ashing displayed value becomes xed

and then the OFF or StoP indication is displayed;

4. press the

button before the OFF or StoP is displayed

(while the hour value is still ashing) to continue to the setting

of the minutes;

5. press the

button to increase the minutes; press the

button to decrease them. Each change in value is indicated

by a brief beep;

6. do not press any button for 20 seconds, and the setting

phase will end. The ashing displayed value becomes xed

and then the OFF or StoP indication is displayed.

7. press the

button before the OFF or StoP indication is

displayed (while the minutes are still ashing) to continue to

the setting of the next parameter: SETTING THE BOLUS

DOSE VOLUME.

SECTION 14

NOTE

If you keep pressing either the or the button, it is possible to quickly

change the hours and minutes.

PROG