User guide

MAN 01/EN/03 CRONO PAR 50 06/13

Auto

ASSIGNING THE FLOWS OVER THE DAILY 24-HOUR PERIOD

Proceed as follows:

1. the rst two digits of the display show the hour of the day

(24-hour clock) while the last two show the selected ow

for the corresponding hour of the day. The rst three digits

are steady, but the last numeric digit, after the F (0, 1, 2 or

3) indicating the ow, is ashing;

2. press the

button to select the hour of the day;

then press the

button to select the required flow

corresponding to the selected hour of the day. Each change

is indicated by a beep. Press the

button again to change

the display to the next hour: press the

button to select

the required ow. Proceed in the same way to set the ows

for each successive hour;

3. do not press any button for 20 seconds, and the setting

phase will end. The ashing displayed value becomes xed

and then the OFF or StoP indication is displayed;

4. press the

button before the OFF or StoP indication

is displayed (while the hourly ow value is still ashing) to

continue to the setting of the next parameter: SETTING

THE PARTIAL VOLUME.

SECTION 14

NOTE

PROG

You can set a different ow rate for every hour of the day, choosing between

the four available rates (F0, F1, F2, F3).

If you set the F0 ow rate for any hour, during that hour no drug will be

administered, as the ow rate will be 0.00 ml/h: the display shows the remaining

time of the infusion, and pressing the

button will temporarily display F0

with the value of 0.00 ml/h.