User guide

82
MAN 01/EN/03 CRONO PAR 50 06/13
1 - Before lling the reservoir
Unscrew and screw back the piston rod to fa-
cilitate its unscrewing after you have lled the
reservoir.
2 - Filling the reservoir
The liquid must be aspirated slowly.
Do not ll the reservoir more than the maxi-
mum level allowed of 50 ml.
The rod must be unscrewed with a fairly rapid
movement.
3 - Connection of the reservoir to the pump
To avoid any leakage of the drug while the
reservoir is being connected to the pump, you
can use the infusion set, as an alternative to
the Luer- Lock cap indicated on page 78.
While connecting the reservoir to the pump,
hold them as shown in the gure.
When making the connection, avoid exerting
any pressure on the reservoir walls, because
this could cause liquid to leak past the piston
rings.
While lling the reservoir and connecting it to
the pump, a small leakage might occur betwe-
en the rst and second rings on the rubber
piston. This does not compromise either the
correct working of the reservoir or the delivery
of the drug.
WARNING
SECTION 15