Specifications

Please read this manual before installing and using the heater.
Safety warnings
5
24
To remove the heat exchanger
Please refer to manufacturer.
To replace the burner and spark/sense electrodes
What to do if you smell gas
1. Turn OFF the main gas supply.
2. Extinguish any open flame.
3. Open windows.
4. Do not touch electrical switches.
5. Do not use your telephone.
6. Call your gas supplier immediately from a neighbour’s phone.
Warnings
1. Improper installation, adjustment, alteration, service or maintenance can cause
injury or property damage. Refer to the sections of this manual for correct
procedures, or consult with place of purchase, a licensed plumber, a gas supplier
or the CANNON distributor listed in this manual.
2. Install the heater only in locations that are referred to in the installation instructions.
Do not build the heater into bookcases, walls or enclosures without the use of a
Mock Fireplace kit if appropriate for that type of installation.
3. Due to high temperatures the room heater should be located out of traffic and away
from:
Furniture and draperies
Combustible materials
Gasoline and other flammable liquids
Do not place clothing or other flammable material on or near the heater.
4. Keep curtains*, clothes, furniture and other flammable materials at least
900mm from front and sides of heater.
* At the owner’s discretion curtain clearance can be less than 900mm as
long as they are restrained from the front, top and sides of the heater. The
manufacturer takes no responsibility if curtain clearance is less than 900mm
and not restrained.
5. Children and adults should be alerted to the hazard of high surface temperature
and should take care to avoid burns or clothing ignition.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
6. Never attempt to burn paper or any other material in the heater.
7. Do not place articles on or against this appliance.
Do not use or store flammable materials near this appliance.
Do not spray aerosols in the vicinity of this appliance while it is in
operation.
Do not modify this appliance.
40
Tel: [phone]
1. Remove the logs from the burner chamber.
2. Remove the burner chamber front inspection panel, 4 screws.
3. Disconnect the 16mm nut at the outlet of the gas control.
4. Disconnect the spark and sense electrodes from the ignition module
(device).
5. Remove the burner fixing brackets (2) from the Left and Right hand side of
the burner. Lift the burner assembly upward and carefully remove from the
burner chamber.
6. Replace in reverse order, checking correct location of spark/sense
electrodes. Spark gap between electrode and surface of burner is 4 - 6
mm. Check for gas tightness. For log placement refer page 14 of this
manual.