Bicycle Accessories User Manual

8
seat post / binder
KF362/BBQ
KF115/
Figure 4.
Installation
1. Make sure the seat post, binder, and seat
tube are clean. Use a dry towel.
2. Apply small amount of seat post gel to seat
post surface and reinstall the post into the
seat tube.
4. Tighten the seat binder with a torque
wrench. DO NOT EXCEED MAXIMUM
SPECIFIED TORQUE 6.8Nm.
5. Check tightening torques of the saddle to
seat post clamp bolts. Too much torque
may fail the bolts. Too little torque will
result in movement which leads to fatigue
and bolt failure.
WARNING
TO AVOID SEAT POST OR FRAME
DAMAGE:
• Follow seatpost manufacturer’s
instructions
• Use a torque wrench to tighten.
• Use only seat post gel to lubricate.
• Do not use solvents, or chemical spray
cleaners to clean.
• Never force a seat post into the seat
tube.
• After any crash, fall, or impact, remove
and inspect the seat post for damage
(e.G., Cracks, scratches, scrapes, gouges,
splintering). If damage is found, do not
ride it; discard it. Replace the seat post
with a new one.
YOU CAN BE SEVERELY INJURED,
PARALYZED OR KILLED IF YOUR IGNORE
THESE WARNINGS.