Model 1030E Standalone Enclosure User Manual
NOTICE! This device contains static sensitive components. It should be handled only with proper Electrostatic Discharge (ESD) grounding procedures. NOTE! Cet équipement contient des composants sensibles aux décharges électro-statiques. Il doit absolument être manipulé en respectant les règles de mise à la terre afin de prévenir de telles décharges.
Model 1030E Standalone Enclosure User Manual The Model 1030E standalone enclosure shown in Figure 1 supports one 2U-sized module. The front provides a slot for one module. The back includes either an AC power cord socket or a DC power inlet. Figure 1. Model 1030E Standalone Enclosure Installing and Using the 1030E Enclosure 1. Place the 1030E on a secure surface with room for air flow and within reach of the power source. 2.
Figure 2. Connecting Wires to Terminal Block 5. Connect the power cables to the power source. 6. Insert the terminal block into the DC power inlet at the rear of the 1030E. This turns on the power. To turn off the power, unplug the terminal block from the DC power inlet. Figure 3.
Specifications Physical Dimensions: 10.0"L x 6.25"W x 1.5"H (254 mm x 159 mm x 38.1 mm) Weight: 3.0 lbs (1.4 kg) Power: AC 100 to 240 VAC; 50 to 60 Hz autoranging, 10W maximum DC -36 VDC to -72 VDC, 0.5A, 15W maximum Operating Environment: 0° to +50°C 10 to 90% relative humidity (Non-condensing) Regulatory Compliance • • • • • • • • ETL, cETL (UL 60950 CAN/CSA C22.2 No.
CANOGA PERKINS CORPORATION 20600 Prairie Street Chatsworth, California 91311-6008 USA Phone: (818) 718-6300 FAX: (818) 718-6312 Web Site: www.canoga.com Email: fiber@canoga.