Model 1040 Standalone Enclosure User Manual
NOTICE! This device contains static sensitive components. It should be handled only with proper Electrostatic Discharge (ESD) grounding procedures. NOTE! Cet équipement contient des composants sensibles aux décharges électro-statiques. Il doit absolument être manipulé en respectant les règles de mise à la terre afin de prévenir de telles décharges.
Model 1040 Standalone Enclosure User Manual The Model 1040 standalone enclosure, shown in Figure 1, supports one 5U-sized managed module. Figure 1. Model 1040 Standalone Enclosure The front provides two switches, five LEDs, one connector, and a slot for a module. The back includes an AC power cord socket and the ALM IN and ALM OUT connectors.
Installing and Using the 1040 Enclosure To use the 1040 enclosure, see Figure 1 and follow these steps: 1. Place it on a secure surface with room for air flow and within 7 ft. (2.134 m) of the AC power source. 2. Insert a module in the guide rails and press it firmly into the backplane, then secure the thumbscrews finger-tight. 3. At ALM OUT, on the rear panel, connect devices to receive alarm information; see Figure 2.
Limited Lifetime Warranty Effective July 1, 2005 and After, Canoga Perkins warrants that, at the time of sale, and, for its lifetime, with certain exceptions noted below, every Canoga Perkins' labeled product purchased will be free from defects in material and workmanship for its lifetime, if properly installed and used in conformity to Canoga Perkins' published specifications. This warranty covers the original user only and is not transferable.
Limitations Canoga Perkins may at its sole discretion modify its Limited Warranty at any time and from time to time. Other than those expressly stated herein, THERE ARE NO OTHER WARRANTIES OF ANY KIND, EXPRESSED OR IMPLIED, AND SPECIFICALLY EXCLUDED BUT NOT BY WAY OF LIMITATION, ARE THE IMPLIED WARRANTIES FOR FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY.