Model 1040 Standalone Enclosure User Manual
NOTICE! This device contains static sensitive components. It should be handled only with proper Electrostatic Discharge (ESD) grounding procedures. NOTE! Cet équipement contient des composants sensibles aux décharges électro-statiques. Il doit absolument être manipulé en respectant les règles de mise à la terre afin de prévenir de telles décharges.
Model 1040 Standalone Enclosure User Manual The Model 1040 standalone enclosure, shown in Figure 1, supports one 5U-sized managed module. Figure 1. Model 1040 Standalone Enclosure The front provides two switches, five LEDs, one connector, and a slot for a module. The back includes an AC power cord socket and the ALM IN and ALM OUT connectors.
Installing and Using the 1040 Enclosure To use the 1040 enclosure, see Figure 1 and follow these steps: 1. Place it on a secure surface with room for air flow and within 7 ft. (2.134 m) of the AC power source. 2. Insert a module in the guide rails and press it firmly into the backplane, then secure the thumbscrews finger-tight. 3. At ALM OUT, on the rear panel, connect devices to receive alarm information; see Figure 2.
Warranty Information Current Warranty information is available on-line in the Client Login Area of the Canoga Perkins web site (www.canoga.com) or by contacting Technical Support at 800-360-6642 (voice) or fiber@canoga.com (email).
CANOGA PERKINS CORPORATION 20600 Prairie Street Chatsworth, California 91311-6008 USA Phone: (818) 718-6300 FAX: (818) 718-6312 Web Site: www.canoga.com Email: fiber@canoga.