User Manual

EdgeAccess Universal Chassis System
8. If you will directly manage the 6703, such as in a UCS 1001 or 1050 standalone enclosure, follow
these steps:
a. Plug the RJ-48 serial cable into the console port on the front of the 6703.
b. Plug the other end of the serial cable into an RJ-48 to DE-9 adapter, then into the modem or
the COM port on the PC.
c. Set the TRM/MDM switch to TRM for local management through a local terminal or to
MDM for remote management through a dial-up modem.
9. For ease of maintenance, label each cable and connector with the signal name and direction.
2.2 Front Panel LEDs
The front panel includes LEDs that show general status for the 6703 and specific status for each Rx
and Tx port. See Table 1.
Table 1. 6703 LEDs
LED Status Indicates
Status Off No power
Green Normal operation
Amber Power-on process
Blinking amber Running Bootcode during power-on
Red Hardware failure
Local Rx Green Received signal is above threshold (normal
operation)
Red Received signal is below threshold
Local Tx Off Disabled
Green Enabled
Blinking amber Local Rx and Tx are in loopback mode
Remote Rx Green Port is active and received signal is above threshold
(normal operation)
Amber Port is inactive and received signal is above
threshold (secondary port)
Red Received signal on port is below threshold
Blinking red SFP not certified by Canoga Perkins
Remote Tx Off Disabled
Green Enabled
Blinking amber Remote Rx and Tx are in loopback mode
Blinking red SFP not certified by Canoga Perkins
CWDM Transponder Model 6703
2-2