User guide

Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: [phone], FAX [phone] www.canoga.com
P/N 6942580 Rev A Page 7 of 8
Canoga Perkins Corp. EdgeAccess Ethernet Media Converter 03-Oct-2005
Model L351-1075 V03.40 F37 Standalone 11:00:54
----------------------------------FUNCTIONAL CONFIGURATION----------------------
Local Remote
Chassis/Slot Standalone Offline
User Port Speed/Duplex Link Down
Switch Settings:
User Port Speed 10M
User Port Autonegotiation Enabled
User Port Duplex Half
Side Band Mgmt Enabled
LLF Extension to User Disabled
LLF User to Extension Disabled
RMTF Enabled
1) Configuration Option Control Software
2) User Port Speed/Duplex 10M/Half
3) RMTF Disabled
4) Link Loss Fwd Disabled
Hit SPACE: toggle selection. ENTER: accept. ESC: cancel.
------------------------------------Messages------------------------------------
Alarm Outputs: None
Figure 11. Functional Configuration screen
Step 7: Cable Connection
Once the changes are made to the modules, the UTP (Unshielded Twisted Pair) or fiber optic
cables can be installed. Remember that the USR port is the port connected to your local/client
device and the EXT port is the port facing the network/trunk. Connect the fiber to the EXT port.
Figure 12. Fiber optic and UTP cable connection
Step 8: IP Address/Subnet Mask/Default Gateway Set-up
To configure the IP address, select “5,” press enter, and type the IP address you wish to assign to
the unit. Press enter to accept the changes. The Subnet Mask and Default Gateway must be
entered at this point as well, and note that the Subnet Mask and Default Gateway must be in the
same class as the IP address, i.e. Class A, Class B or Class C.