Manual

Insufficient paper for job
Insufficient paper for job
Cause Corrective Action
The printer has received a print job longer than the amount of roll paper left when Manag-
eRemainRoll in the Control Panel menu is On.
Press ▲ or ▼ to select Print, and
then press the OK button to resume
printing.
However, the roll paper may run out
during the print job and you may not
be able to print all of the document.
Press ▲ or ▼ to select Change Pa-
per, and then press the OK button to
stop printing.
(See "Removing the Roll from the
Printer.") ➔P.21
(See "Loading Rolls in the Print-
er.") ➔P.15
Press ▲ or ▼ and select Stop Print-
ing or press the Stop button to stop
printing.
This paper cannot be used as size is not supported.
This paper cannot be used as size is not supported.
Cause Corrective Action
Paper that is too large for the printer has been
loaded.
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.") ➔User's Guide
Paper that is too small for the printer has been
loaded.
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.") ➔User's Guide
Paper has been loaded that is too small to
print the test pattern for printhead adjustment
or nozzle checking.
Lift the Release Lever and load unused paper A4/Letter (vertical) or larger. More
than one sheet may be required depending on the adjustment.
Cannot print as selected. Another roll is in use.
Cannot print as selected. Another roll is in use.
Cause Corrective Action
A printed document remains in the Output Tray without being cut
and a print job was received that specifies the other roll.
Press the OK button to stop printing.
Cut the printed document.
(See "Specifying the Cutting Method for Rolls.") ➔ User's Guide
Load the other roll and resend the print job.
(See "Loading and Printing on Rolls.") ➔ User's Guide
Roll printing is selected.
Roll printing is selected.
Cause Corrective Action
You have attempted to print on a roll,
but no roll is loaded.
Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll,
and then print.
(See "Attaching the Roll Holder to Rolls.") ➔ P.12
(See "Loading Rolls in the Printer.") ➔ P.15
Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.
Roll printing is selected, but sheets are loaded.
Roll printing is selected, but sheets are loaded.
Cause Corrective Action
A print job for rolls was received when a
sheet is loaded.
Follow these steps to load and print on a roll.
1.
Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove the sheet.
(See "Removing Sheets.") ➔P.28
2. Load a new roll.
Insufficient paper for job iPF840 Series
Basic Guide
Error Message Messages regarding paper
128