Use and Care Manual
100
Before Use
Basic Guide
Advanced Guide
Wi-Fi Functions
Camera Basics
Auto Mode / Hybrid Auto
Mode
Other Shooting Modes
P Mode
Playback Mode
Setting Menu
Accessories
Appendix
Index
7
Establish the connection.
● On the access point, hold down the WPS
connection button for a few seconds.
● On the camera, press the [
] button to
go to the next step.
● The camera connects to the access point
and lists devices connected to it on the
[Select a Device] screen.
8
Choose the target device.
● Press the [ ][ ] buttons to choose the
target device name, and then press the
[
] button.
9
Install a driver (rst Windows
connection only).
● When this screen is displayed on the
camera, click the Start menu on the
computer, click [Control Panel], and then
click [Add a device].
● Double-click the connected camera icon.
● Driver installation will begin.
● After driver installation is complete, and
the camera and computer connection
is enabled, the AutoPlay screen will be
displayed. Nothing will be displayed on
the camera screen.
● After [Device Nickname] is displayed,
press the [ ][ ] buttons to choose [OK],
and then press the [ ] button.
3
Choose [ ].
● Press the [ ][ ][ ][ ] buttons to choose
[ ], and then press the [ ] button.
4
Choose [Add a Device].
● Press the [ ][ ] buttons to choose [Add
a Device], and then press the [ ] button.
5
Choose [WPS Connection].
● Press the [ ][ ] buttons to choose
[WPS Connection], and then press the
[ ] button.
6
Choose [PBC Method].
● Press the [ ][ ] buttons to choose [PBC
Method], and then press the [ ] button.