User Manual

29
3 Select the [Thin Paper Mode] check box.
4 Click to close the dialog box.
Placing Cards
When scanning cards, switch the scanner to non separation mode and
then place one card at a time horizontally.
1 Switch the scanner to non separation mode.
2 Adjust the document guides to fit the width of the card to
be scanned.
3 Place the card horizontally, with the reverse side facing
you, and the top of the card facing down.
CAUTION
• Place the cards one at a time.
• When scanning cards, place them to be fed horizontally. If you
place cards to be fed vertically, they may not be ejected properly,
and cards that get jammed may be damaged when you remove
them.
Hint
Up to 3 cards can be placed in the scanner at the same time if they
are not embossed. In such a case, turn off non separation mode
before scanning.