User Manual

149
Connecting to a Wi-Fi Network
Manual Setup
If you prefer, you can enter manually the details of the Wi-Fi network you want to connect to. Follow the
instructions on the screen to complete the procedure.
1 Open the [Set Up New] submenu.
[w Other Functions] > [Network Settings] > [Connection Settings]
> [Set Up New]
2 Select the [Manual] method.
[Infrastructure] > [Manual]
3 To enter the [SSID] (network name), select [Input] and then press
the joystick.
• Enter the SSID (network name) of the selected Wi-Fi network using
the keyboard screen (A 148).
• After entering the network name, select [OK] and then press the joystick.
4 Select the Wi-Fi network’s authentication method and then press the joystick.
• If you selected [Shared Key], skip to step 6.
5 Select the Wi-Fi network’s encryption method and then press the joystick.
• If the authentication method is [Open], you can select [WEP] and continue to step 6, or [No encryption] and
skip to step 7.
• If the authentication method is [WPA-PSK] or [WPA2-PSK], you can select [TKIP] or [AES].
6 Enter the encryption key as described in Encrypted Access Points (A 148).
7 Continue with the procedure to configure the IP address assignment (A 150).
Camera Access Point
In this mode the camcorder itself serves as a wireless access point to which other Wi-Fi-enabled devices can
connect. Follow the instructions on the screen to complete the procedure.
1 Open the [Set Up New] submenu.
[w Other Functions] > [Network Settings] > [Connection Settings]
> [Set Up New]
2 Select [Camera Access Point].
3 To enter the [SSID] (network name), select [Input] and then press
the joystick.
• Enter the SSID (network name) the camcorder will use as a Wi-Fi
access point using the keyboard screen (A 148).
• The network name is needed to connect the network device to the
camcorder. If necessary, write it down.
4 Select the wireless connection mode (5 GHz band or 2.4 GHz band) and then press the joystick.
• The 5 GHz frequency band is not available for all models (A 203).
5 Select the channel and then press the joystick.
• Available channels will be different depending on the wireless connection mode selected in the previous
step.
6 Select the encryption method and then press the joystick.
• If you selected [Open/No encryption], skip to step 8. If you selected [WPA2-PSK/AES], continue with step 7.
[w Other Functions]
[Network Settings]
[Connection Settings]
[Set Up New]
[w Other Functions]
[Network Settings]
[Connection Settings]
[Set Up New]