Owner's Manual
Table Of Contents
- Owners Manual
- Time / Date Set
- Supplied Accessories
- Conventions Used in This Manual
- Quick Start
- Table of Contents
- Parts & Controls
- Getting Started
- Attaching the Strap
- Charging the Battery
- Installing / Removing the Battery
- Battery Status Indicator
- Mounting / Detaching a Lens
- Installing / Removing a CF Card
- Basic Operation
- Menu Operation
- Language Set
- Time / Date Set
- Replacing Date / Time Battery
- Cleaning CMOS Sensor
- Auto-Off
- CF Card Reminder
- Adjusting Viewfinder
- Holding the Camera
- Basic Operation
- Menu Operation
- Shooting in AUTO Mode
- Image Settings
- Setting AF / Metering / Drive Modes
- Advanced Operations
- Using a Flash
- Image Playback
- Direct Printing from the Camera
- DPOF
- Customizing the Camera
- Function Availability Chart
- Troubleshooting
- Error Codes
- Specs
- Index
- Pocket Reference Guide
- Battery Pack Info
- EF Zoom Lens Info
- Arcsoft Photo Studio Info
- Software Quick Start Guide
- Scans of Supplied CD-ROMS
- Note - Install Software Before Connecting to Computer
- Note - Use Genuine Canon Accessories
- Canon EOS Brochure
- Warranty
Troubleshooting Guide
If
there is a problem, first refer to this Troubleshooting Guide. If this
Troubleshooting Guide does not resolve the problem, contact your
dealer or nearest Canon Service Center.
Power Source
The
battery
cannot
be
recharged.
<iii
You are
using
the
wrong
battery.
~
Use Battery Pack NB-2LH.
ill!
The battery pack
is
not
properly attached
to
the battery charger.
ilJv
Attach the battery pack properly to the charger. (p.20)
The
camera does not operate even
when
the power switch is set to
<ON>.
~
The
battery
is
exhausted.
~
Recharge the battery pack. (p.20)
%}
The
battery
is
not
installed
properly.
!>
Install the battery properly. (p.22)
@l
Battery
compartment
cover
is
not
closed.
~
Close the battery compartment cover securely. (p.22)
@ CF
card
slot
cover
is
not
closed.
l'F
Close the CF card slot cover securely. (p.26)
The access lamp still blinks even when the power switch is set
to
<OFF>.
If
you
set
the
power
switch
to
<OFF>
right
after
shooting,
the
access
lamp
will
still
light/blink
for
a
few
seconds
until
the
camera
finishes
recording
the
image
onto
the
CF card.
When the camera finishes recording the image to the CF card, the
access lamp will stop blinking and the power will turn off
automatically.
The
battery
becomes
exhausted
quickly.
@>
The
battery
is
not
fully
charged.
IP
Recharge the battery fully. (p.20)
<ill
The
battery's
service
life
has
expired.
iJl>
Replace the battery pack with a new one.
154