Owner's Manual

Max. Burst
~ Selecting the Drive Mode ., _ ........
Single and continuous drive modes are provided. In the Basic Zone
modes, the optimum drive mode is set automatically.
Press the < ~ &~ > button. (06)
Look at the LCD panel and press the
< ~ ~~ > button to select the drive
mode.
o : Single shooting
When you press the shutter
button completely, one shot will
be taken.
~ Continuous shooting
(Max. 3 shots per sec.)
While you press the shutter
button completely, shots will be
taken continuously.
~~ : Self-timer/Remote control
(p.48/49)
During continuous shooting, the captured
images are first stored
in the camera's
buffer memory and then successively
transferred to the CF card. When the
buffer memory becomes full during continuous shooting, "buSY" will be
displayed on the LCD panel and
in the viewfinder and the camera cannot
take any more shots. As the captured images are transferred to the CF
card, you will be able to capture more images. Press the shutter button
halfway to check
in the viewfinder's bottom right the current remaining
shots of the maximum burst.
If
"FuLL CF" is displayed in the viewfinder and on the LCD panel, wait
until the access lamp stops blinking, then replace the CF card.
When the battery level is
low, the maximum burst will be slightly lower.
78