Owner's Manual

--
_
_
B·~··I······~····B_··
B ~ I~tB.
P Program AE
® If "30
11
" and the maximum aperture blink, it indicates
that the subject is too dark. Increase the ISO speed
or use flash.
® If "4000" and the minimum aperture blink, it indicates that the
subject is too bright. Decrease the ISO speed or use an ND
filter (optional) to reduce the amount of light entering the lens.
Image-Recording Settings
RAW, RAW+.t selection
ISO speed setting
White balance selection
Custom white balance selection
White balance correction
WB bracketing
Color space selection
Processing parameter setting
Flash Settings (Built-in flash)
Flash On/Off
FE lock
Flash exposure compensation
r=¥l
UJ Differences Between<P> and <0> {Full Auto)
@ Inbothmodes, you canfreely change the automatically-set shutter
speed
and aperture combination (program).
In the< P> mode, you can set· or use the functions . below, but not in the <0 >. mode.
Shooting Settings Flash Settings (EX-series Speedlite)
AF mode selection Manual/stroboscopic flash
AF point selection High-speed sync (FP flash)
Drive mode selection FE lock
Metering mode selection
® Flash ratio control
® Program Shift Flash exposure compensation
Exposure compensation FEB
@ AEB 2nd-curtain sync
@ AE lock with < *> button @ Modeling flash
@ Depth-of-field preview
Clear all camera settings
Custom Function (C.Fn)
Clear all Custom Functions
Sensor cleaning
About Program Shift
In Program AE mode, you can freely change the shutter speed and
aperture value combination (program) set by the camera while
maintaining the same exposure value. This is
called program shift.
® To do this, press the shutter button down halfway, then turn the < B >
dial until the desired shutter speed or aperture value is displayed.
Program shift is canceled automatically after the image is captured.
If you use flash, you cannot use program shift.
81