User Manual

E2
① Iris Gain Adjusting Trimmer
② Focus Ring A
③ Focus Ring B
④ Max. Zoom Speed Adjusting Volume
⑤ Instant Auto-Iris Switch
⑥
Iris Operation Mode Change-over Switch
⑦ Zoom Rocker Seesaw
⑧ RET Switch (Video Return Switch)
⑨ VTR Switch
⑩
AUX
Switch
⑪ Flange Back Lock Screw/Flange Back
Adjusting Ring
⑫ Macro Button/Macro Ring
⑬ Extender Switching Lever
⑭ MEMO Switch (Memory Switch)
⑮ Iris Ring
⑯ Zoom Lever/Zoom Ring
⑰ L
ens Holder
⑱ Lens Cable Connector (12-pins)
NOTE) PL mount lens only
⑲ Zoom/Focus Remote, Iris Remote,
Virtual Connectors (20-pin)
NOTE) Only connector ★ can be used as the iris remote
or virtual output port.
Use these connectors to connect the control accessory
(equipped with a 20 pin connector) for zooming or focusing.
Connector ★ has also a function to operate the iris through
a focus control accessory and a dedicated cable and a
function to interface with various virtual systems. It can
output each positioning signal of zoom, focus, and iris.
⑳ Zoom/Focus Operation Change-over Knob
㉑ Hood Lock Knob
㉒
Attachment Holder Contact Plate
㉓
Tie Cable
①
Display Switch
Used to turn the display ON/OFF.
②
Display
It turns off if left for 2 minutes without operation.
③
Control key
Used to move the cursor up/down/left/right. Press the
center to conrm.
1 NOMENCLATURE
Information Display (Digital Drive Unit)
1 NOMENCLATURE
For the operation of the digital drive unit, refer to the "Information Display Manual" on the CD-ROM.
①
②
③
④
⑤
⑥
⑦
⑧ ⑨
⑩
⑪
⑫
⑬
⑭
⑮
⑯
⑰
󰚧
⑱
⑲
⑳
󰚜
󰚨
PL Mount Lens Only
①
②
③